I nstallation
Electrical connection
1. Do not use an extension cord or double adapter.
2. If the supply cord is damaged, it must be replaced by the manufacturer or its service agents or similarly qualified person in order to avoid a hazard.
3. Always unplug the machine and turn off the water supply after use.
4. Connect the machine to an earthed socket in accordance with current wiring regulations.
5. The appliance must be positioned so that the plug is easily accessible.
•Repairs to the washing machine must only be carried out qualified personnel. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local service center
•Do not install your washing machine in rooms where temperatures below freezing may occur. Frozen hoses may burst under pressure. The reliability of the electronic control unit may be impaired at temperatures below freezing point.
•If the appliance is delivered in the winter months and temperatures are below freezing : Store the washing machine at room temperature for a few hours before putting it into operation.
Washing Machine is to be connected to the water mains using new hoses
Old hoses should not be used. Connecting water supply hose
Hose connector
Sealing washer
|
| Hot water tap | |
|
| Cold | |
Cold | Hot(option) | water | |
tap | |||
|
|
■Water supply pressure must be between 4.5 ~ 145 PSI (30~1000 kPa)
■Don’t strip or crossthread when connecting Inlet hose to the valve.
■If the water supply pressure is more than 1000 kPa, a pressure reducer device should be installed.
•Two Sealing washer are supplied with the water inlet hoses to prevent water leaks.
•Check water tightness of washing machine connections by turning the tap completely on.
•Periodically check the condition of the hose and replace the hose if necessary.
•Make sure that there is no kink in the hose and that it is not crushed.
•The Inlet hose which has red connector is for the hot water tap.
•Hot and cold water faucets Must be installed of your washer’s water inlet.
7