ENGLISH
ELECTRICAL CONNECTIONS
To prevent short circuits, we recommend that you disconnect the batteryʼs negative terminal and make all electrical connections before installing the receiver.
•Be sure to ground this receiver to the car’s chassis again after installation.
Notes:
•Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC car audio dealer.
•It is recommended to connect to the speakers with maximum power of more than 50 W (both at the rear and at the front, with an impedance of 4 Ω to 8 Ω). If the maximum power is less
than 50 W, change “AMP GAIN” setting to prevent the speakers from being damaged (see page 14 of the INSTRUCTIONS).
• To prevent
• The heat sink becomes very hot after use. Be careful not to touch it when removing this receiver.
ATypical connections /
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause serious damage to this receiver.
The leads of the power cord and those of the connector from the car body may be different in color.
1Connect the colored leads of the power cord in the order specified in the illustration below.
2 Connect the antenna cord.
3 Finally connect the wiring harness to the receiver.
Rear ground terminal
Line out (see diagram )
Antenna terminal
*2 Before checking the operation of this receiver prior to installation, this lead must be connected, otherwise power cannot be turned on.
15
15 A fuse
Black
Yellow*2
Red
Blue
Blue with white stripe
*1 Not included for this receiver
To metallic body or chassis of the car
To a live terminal in the fuse block connecting to the car battery (bypassing the ignition switch) (constant 12 V)
To an accessory terminal in the fuse block
To the automatic antenna if any (250 mA max.)
To the remote lead of other equipment (200 mA max.)
Ignition switch
Fuse block
White with black | White | Gray with black stripe | Gray | Green with black stripe | Green | Purple with black stripe | Purple |
stripe |
|
|
|
|
|
|
|
| Left speaker (front) | Right speaker (front) | Left speaker (rear) | Right speaker (rear) |
BConnecting the external amplifier /
You can connect an amplifier to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this receiver.
• Disconnect the speakers from this receiver, connect them to the amplifier. Leave the speaker leads of this receiver unused.
Rear speakers
Remote lead |
JVC Amplifier
Remote lead (Blue with white stripe)
Signal cord (not supplied for this receiver)
To the remote lead of other equipment or automatic antenna if any
KD-G116
KD-G115
Front speakers
*3 Firmly attach the ground wire to the metallic body or to the chassis of the
PRECAUTIONS on power supply and speaker connections:
•DO NOT connect the speaker leads of the power cord to the car battery; otherwise, the receiver will be seriously damaged.
•BEFORE connecting the speaker leads of the power cord to the speakers, check the speaker wiring in your car.
2