Connection options
A Cold water connectionand
B Hot water connection(max. 140 °F /60 °C)
min. 10 mm
or Cold water connection only with YCpiece
min.
10 mm
q After the connection:
Turn on the water completely, and check whether connection points are watertight.
CAUTION
The connection points are under full water pressure. Check seal with tap fully open.
Water drainage
CAUTION
Do not bend or pull the water drainage hose.
Height difference between the placement area
of washer | and | the | drainage point: |
Maximum 110 cm / | 43 inches. | ||
Standpipe | or | In | Wall Installation |
q Use the UTbracket. Attach the UTbracket to t end of the hose and insert end of hose into standpipe or wall drain.
q Use a | strap | or cable tie connected to UTbra |
to hold hose in place. | ||
Drainage | into | a siphon |
q Secure the connection point with a hose clamp.
32