Electrolux 50815 manual Clean it

Problem	Possible cause	Remedy
	The tap is turned off.	Turn on the tap.
The END indicator is	The filter in the inlet hose	Turn off the tap. Unscrew the
flashing 1x.		hose, remove the filter and
	screw connection is blocked.
(Problems with the wa-		clean it.
ter inflow.)	The tap is blocked by limes-	Check the tap and have it re-
	cale or is faulty.	paired, if necessary.
	The transport lock has not	Removing the transport lock.
The washing machine	been removed.
vibrates when operating	The screw feet not correctly	Adjust the feet as described
or is not stable.
		in the installation and con-
	adjusted.
		nection instructions.
		Always load the drum as full
Washing has not been	Only a few large items of
		as possible. Mix large and
spun.	washing in the drum.
		small items.
	The inlet hose screw con-	Tighten the inlet hose.
	nection is leaking.
	The outlet hose is leaking.	Replace outlet hose.
Water is running out	The drain pump lid has not	Close the cover properly.
from under the washing	been closed properly.
machine.	Washing was caught in the	Load washing carefully for
	door.	the next wash.
	The emergency drain hose is	Screw on the emergency
	leaking.	drain hose firmly.
	Too much detergent has	Follow the manufacturer's
There is a lot of foam.		instructions exactly when
	probably been used.
		measuring out detergent.
	There is a kink in the outlet	Straighten the hose.
	hose.
	The maximum pump height	Please contact your local
The END indicator is	of 1m has been exceeded.	Service Force Centre
		Switch off the appliance.
flashing 2x.
(Problems with the wa-	The drain pump is blocked.	Disconnect the power plug.
ter outflow.)		Clean the drain pump. Re-
		move foreign bodies from
		the pump housing.
	For sink spigot connections:	Clean the spigot.
	the spigot is blocked.

19