Electrolux 50815 manual Water inlet, Water Drainage, Open the porthole and extract the inlet hose

Page 32

Water inlet

Attention!

•An inlet hose is supplied and can be found inside the machine drum.

•Do not use the hose from your previous machine to connect to the water supply.

•This appliance must be connected to a cold water supply.

1.Open the porthole and extract the inlet hose.

2.Connect the hose with the angled connection to the machine.

Important!

Do not place the inlet hose down- wards. Angle the hose to the left or right depending on the position of your water tap.

3. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.

4.Connect the hose to a tap with a

3/4” thread.

Always use the hose supplied with the appliance.

Water Drainage

The appliance drain hose should hook into a standpipe, the hook in the drain hose is formed using the plastic “U-Piece“ supplied. The standpipe should have an internal diameter of approximately 38 mm (see dia- gram) thus ensuring there is an air break between the drain hose and standpipe.

Important! It is essential to lay the drainage hose without kinks.

32

Image 32

Contents Lavamat Following symbols are used in the text Dear CustomerContents Installation and connection instructions Safety information concerning installationSafety Prior to using the appliance for the first timeChild safety Follow the Installation and connection instructionsGeneral safety Resulting overheating may constitute a fire hazardDescription of the appliance Control panelProgramme overview DrainApplication/Features Care Symbols1 Before the first wash Preparing and sorting washingPreparing washing Sorting washingRunning a wash cycle Opening the door/loading washingAdding detergent/conditioner Open the door pull the handle on the doorWashing powder/tablets for the main wash cycle Switching on the appliance/selecting a programmeIf you are using liquid detergent Shortened wash programme for lightly soiled washing Changing the spin speed/selecting rinse holdProgramme Option Buttons Setting the delay timer Activating/deactivating RINSE+Activating RINSE+ Deactivating RINSE+Starting a programme Interrupting a programme/adding washingWashing cycle complete/Removing the washing Interrupting a programmeIf Rinse Hold has been selected Child safety deviceDeactivating the child safety device Cleaning and maintenance Cleaning procedureDetergent dispenser drawer Washing drumRemedying small faults yourself Clean the glass in the door and the rubber collar regularlyWhat to do if Door and rubber collarClean it Foam can still be seen following the final rinse If the wash result is not satisfactoryThere are grey stains on the washing There are white residues on the washing When the water has all drained awayCarrying out an emergency drain Drain pump Old appliance DisposalPackaging material Technical data Consumption valuesSafety information concerning installation This washing machine cannot be built-inInstalling the appliance When using a sack trolley to transport the washing machineTransporting the appliance UnpackingPage Remove the bracket D Refit the six smaller bolts C Where to install Making the appliance levelBrown Live Wire coloured green and yellow Electrical ConnectionConnecting to the water supply Permanent ConnectionPermitted water pressure If more than 10bar Connect a pressure reduction valveOpen the porthole and extract the inlet hose Water inletWater Drainage For drainage into an outlet From your Service Force CentrePumping heights of over 1 metre Great Britain E. Abu Dhabi Jordan Malta Estonia Latvia Poland European Guarantee LU4 9QQMagyarország +36 0870 5 929 Customer CareFor general enquiries concerning Major Appliances132 978 Subject to change without notice