4.Raise or lower two nylon adjustment screws (A, Fig. 27) the same number of turns until the space between the bottom of the fence and the table is the same. Care must be taken to raise or lower the fence on each side equally or the fence may not be 90° to the table after the height adjustment is performed.
Parallel to the Miter Slot Adjustment
1.Place the fence next to the outside edge of the right miter slot and lock it.
2.The fence should be even with the miter slot from front to back.
3.If the fence is not even along the length of the miter slot, unlock the fence, remove it and turn upside down (Figure 28).
4.Adjust one of the two set screws (A, Fig. 28) until the fence is even with the miter slot edge along its entire length when locked.
Note: You may need to
Clamping Pressure Adjustment
The XACTA Fence II has been adjusted at the factory to lock securely when the lock handle is pushed down. If adjustment is needed:
1.Unlock the fence.
2.Remove the fence from the guide rail.
3.Turn the fence over.
4.Adjust each of the two set screws (A, Fig. 28) exactly the same number of rotations until the fence is held securely when the lock handle is pushed down.
A clockwise rotation of the set screws will increase the cam pressure. Counterclockwise rotation will decrease cam pressure.
90° to the Table Adjustment
1.Place the fence on the saw table and lock it.
2.Place a square (A, Fig. 29) on the table next to the fence. The fence should be 90° to the table.
3.If adjustment is necessary, unlock the fence, and turn one of the two nylon adjustment screws (B, Fig. 29) until the fence is 90° to the table.
4.Lock the fence and check the adjustment again.
Initial Cursor Pre-adjustment
Loosen two screws securing the cursor to the fence and adjust the cursor to midrange. This will provide sufficient range for later adjustment if required.
Figure 27
Figure 28
Figure 29
18