Hooks for Miter Gauge and Fence
Hardware: (2) Miter Gauge Hooks, (2) Fence Hooks, (4) M8x16 Carriage Bolts, (4) M8 Flat Washers, (4) M8 Lock Washers & (4) Hex Nuts
Tool: 13mm Wrench
1.Mount the two fence hooks (A, Fig. 38) with two M8x16 carriage bolts, two M8 flat washers, two M8 lock washers and two M8 hex nuts.
Helpful Hint: Removing the rear access door by pulling the release lever (E, Fig. 40) will facilitate reaching the front hook mounting hole.
2.On the opposite side of the cabinet mount two miter gauge hooks with two M8x16 carriage bolts, two M8 flat washers, two M8 lock washers and two M8 hex nuts.
Blade Raising and Tilting Mechanism
1.To raise or lower saw blade, loosen the lock knob (A, Fig. 39) and turn the handwheel (B, Fig. 39) on the saw front until desired height is reached. Tighten lock knob. The blade should be adjusted 1/8" to 1/4" above the top surface of the material being cut, about
2.To tilt the saw blade, loosen lock knob found on the left side of the table saw and turn handwheel until desired angle is obtained, then tighten lock knob.
Electrical Connections
A qualified electrician must complete all electrical connections! Failure to comply may result in serious injury!
The
To switch the
1.Disconnect the machine from the power source, (unplug).
2.Open the cabinet door found on the rear of the saw, by pressing the red release button on the latch assembly. Lift the lever up and pull the door open.
3.You can remove the door by pulling the door release lever down (E, Fig. 40).
4.Remove the cover from the motor junction box (F, Fig. 40).
Figure 38
Figure 39
5.Change wires following the diagram on the inside of the cover.
6.Replace the cover and close the cabinet door.
Confirm power at the site is the same as the saw before making any electrical connections. Review the Wiring Diagrams on pages
Using extension cords can cause a loss in power to your machine. It is best if the saw is plugged directly into an outlet on a dedicated circuit.
Figure 40
21