slot (A. Fig. 21), orient the guide tube (B) with respect to the rail (C) as shown in Figure 21.
If your left table wing is the sliding table type (D, Fig. 22), mount the guide tube (F) so it lines up with the left edge on the angle iron portion of the rail (E).
Referring to Figure 23:
1.Align the holes in the bottom of the guide tube (G) with the holes in the front rail (H).
2.Fasten the guide tube (G) to the rail (H) from beneath with
3.Instructions for the installation of the scale on the guide tube is given after the XACTA fence has been assembled and given a preliminary adjustment.
XACTA Fence
Screw the lock lever knob into the threaded handle on the XACTA Fence II as shown in Figure 24.
The lock lever has three functional positions as shown in Figure 25:
•The upright position permits mounting and removal of fence from the saw.
•The unlock position permits easy fence positioning.
•The lower position locks the fence to the front rail. The cam handle should be pushed down firmly against the pin.
Fence Adjustments
Note: Fence adjustments should be performed in the order given.
Level with the Saw Table Adjustment
1.Place the fence on the table and lock it.
2.View the fence from the left side of the saw. Look for the space between the table and the fence bottom to be equal along the entire length of the fence (Figure 26).
3.If adjustment is necessary, unlock the fence.
Figure 22
Figure 23
Figure 24
Figure 25
Figure 26
17