Mounting the Switch Assembly
Hardware: (2) 1/4x1/2 Hex Cap Screws,
(2)1/4 Lock Washers, (2) 1/4 Flat Washers. Tool: 4mm Hex Wrench
Referring to Figure 15:
Mount the switch assembly (A) to the bottom side of the front rail (B) with two button head cap screws (C) and two washers (D).
Note: The switch assembly can be installed in various locations along the front rail.
On-Off Switch Padlock
Model No. BP-1, Stock No. 709736
To safeguard your machine from unauthorized operation and to avoid accidental starting by young children, the use of a padlock is highly recommended. JET model
Wooden Extension Table
The wooden extension table is an optional accessory.
Hardware: (4)
Tools: Electric drill, Cross point screwdriver, two 10mm wrenches, Straight edge, Hammer (or rubber mallet)
Installation
The optional wood extension table (including the optional router table) sits flush against the saw table and along the inside of the rails. The JET logo (or warning label on the router table) should face outward. The extension table is not bolted to the saw table, it is bolted only to the rails.
The extension table and saw table must be aligned properly so the
1.Place the extension table between the rails and up against the saw table, leaving the extension table raised just slightly above the saw table. Clamp the extension table to the front and back rails as shown in Figure 16. Clamping pressure should be enough to secure the table yet allow minor adjustments.
2.Use a hammer and block of wood (or a rubber mallet) to tap the extension table up flush against the cast iron saw table (Figure 16).
Then tap down the extension table at various points along its edge where it meets the saw
15
Figure 15
Figure 16
Figure 17