Jet Tools JWSS-10CS operating instructions Changing Poly V-Belt, Changing the Transfer Belt

Page 26

Changing Poly V-Belt

Make all machine adjustments or maintenance with the machine unplugged from the power source. Failure to comply may cause serious injury!

1.Disconnect the machine from the power source, unplug.

2.Lower the blade to its lowest point and tilt to 45°. This will allow easy access to the poly v-

belt.

Figure 51

3.Take the tension off of the belt (A, Fig. 51) by lifting up on the motor.

4.Remove the belt from the arbor and motor pulleys.

5.Replace the belt. The weight of the motor and the torsion spring should apply enough tension to the belt.

Changing the Transfer Belt

Referring to Figures 52 and 53:

1.Disconnect the machine from the power source, unplug.

2.Remove the front panel (D) by unscrewing the lock knob (A), pulling off the handwheel (B), and removing five pan head screws (C) that hold the front panel.

3.Remove bolt (F) and pivot assembly up to take the tension off the belt. Take belt off the upper pulley. Remove nut (G) and pull off the assembly.

4.Remove the screw and washer (H) that holds the shaft (I) in place.

5.Loosen the two set screws (J) that hold the timing pulley in place.

6.Pull out the shaft far enough so that you can remove the timing belt (K).

7.Replace with a new belt and reassemble.

8.Make sure timing pulleys are aligned and tighten set screws (J).

9.Make sure tension on the timing belt is enough so that the belt does not slip. Tighten bolt (F).

26

Figure 52

Figure 53

Image 26
Contents Vantage Drive Elgin, Illinois Revision B 07/06 Copyright WMH Tool GroupWarranty and Service More InformationTable of Contents Ordering Replacement Parts Page Page Specifications Protection Tips from Kickback Kickback PreventionContents of the Shipping Containers Xacta Fence II Homeshop 30/52 Left Wing Extension Box optional accessoryTools Required for Assembly Installation Requirements AssemblyUnpacking and Clean-Up Right Extension Wing AssemblyMounting Rails Mounting Left Extension Wing with Miter SlotMiter Gauge for Left Extension Wing Mounting Sliding TablePage Sliding Table Miter Gauge Installation Mounting the Switch AssemblyOn-Off Switch Padlock Wooden Extension TableGuide Tube If you have a 52 Rail SystemFence Adjustments Xacta FenceParallel to the Miter Slot Adjustment Installing the Blade Guide Tube Scale ApplicationAligning Blade Guard and Splitter Blade Guard AssemblyTable Insert Adjustment Blade Raising and Tilting Mechanism Electrical ConnectionsHooks for Miter Gauge and Fence Grounding Instructions Volt OperationBlade Alignment AdjustmentsXacta Fence Cursor Adjustment Adjusting 45 and 90 Positive Stops If blade is not atWear Adjustment in Raising Mechanism Wear Adjustment in Tilting MechanismChanging Poly V-Belt Changing the Transfer BeltBlades and Accessories MaintenanceGeneral Maintenance Troubleshooting Trouble16-18 Xacta Fence II Homeshop 30/52 Fence AssemblyParts TS-1534032 Cabinet Assembly150503-1 TS-2284082TS-1482071 Guard AssemblyTS-2342061 TS-1550041Table Assembly TS-1550021 TS-1540041TS-1482011 TS-1533052Table Assembly Sliding Table Assembly Sliding Table Miter Gauge Complete NH061000TS-1522021 Sliding Table Assembly Rail Assembly Rail Assembly Motor & Trunnion Parts List TS-1523021 JWSS10-64TS-1490071 NH162406Motor & Trunnion Assembly Wiring Diagrams 115V Wiring230V Wiring