Zanussi 192994960-00-202009 user manual Positioning, Water inlet, Water drainage

Page 19

Open the porthole and re- move the polystyrene block fitted on the door seal.

Fill the smaller upper hole and the two large ones with the corresponding plastic plug caps supplied in the bag containing the instruction booklet.

The inlet hose is screwed to the back of the appliance.

Connect the hose to a tap with a 3/4” thread. Always use the hose supplied with the appliance.

35°

45°

Positioning

Install the machine on a flat hard floor. Make sure that air circulation around the machine is not impeded by carpets, rugs etc. Check that the machine does not touch the wall or other kitchen units. Level the washing machine by raising or lowering the feet. The feet may be tight to adjust as they incorporate a self locking nut, but the machine MUST be level and stable.

Any necessary adjustment can be made with a spanner. Accurate levelling prevents vibration, noise and displace- ment of the machine during operation. Never place card- board, wood or similar materials under the machine to compensate for any unevenness in the floor.

If necessary, check the setting with a spirit level.

Water inlet

Warning! This appliance must be connected to a cold water supply

Caution! Before connecting up the appliance to new pipework or to pipework that has not been used for some time, run off a reasonable amount of water to flush

out any debris that may have collected

Caution! Do not use the hose from your previous appliance to connect to water supply.

The other end of the inlet hose which connects to the appliance can be turned as showed in the picture.

Do not place the inlet hose downwards. Angle the hose to the left or right depending on the position of your water tap. Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks.

Caution! The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap,

you will have to purchase a new, longer hose specially designed for this type of use.

Warning! Installation should comply with local water authority and building regulations’

requirements.

The appliance must be connected to a cold water supply. A minimum water pressure of 0.05 MPa (0.5 bar) is required for safe operation of the appliance.

If you cannot make the cold water connection direct from the rising mains, you may be able to operate the appliance from your cold water storage system.

There should be a minimum vertical distance of 5.02 m (16.5 ft) between the appliance’s inlet and the bottom of the water storage tank.

Water drainage

This appliance is designed to be permanently plumbed into your home's drainage system using one of the fol- lowing methods.

1. Into a drainage standpipe.

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Washing Machine ZWF 14069W Safety information ContentsUse Child safetyCompartment for liquid additives fabric softener, starch Product descriptionControl panel Detergent dispenser drawerTable of symbols Daily use First useProgrammes» Select the Delay Start by pressing buttonSelect the available options by pressing buttons 3 Start the programme by pressing buttonHelpful hints and tips Quantity of detergent to be used Detergents and additivesDegrees of water hardness Main wash Rinses Washing ProgrammesDrain Maximum spin speed at 1400 rpm Max. load 5,5 kg Rinses Maximum spin speed at 1400 rpm Max. load 5,5 kgDrain Maximum spin speed at 700 rpm Max. load 3 kg What to do if…Problem Replace it with a new one Consumption values Technical dataCare and cleaning Proceed as follows Disconnect the appliance Cleaning the water inlet filtersUnpacking InstallationFrost precaution Emergency emptying outOut any debris that may have collected PositioningWater inlet Water drainageInterest of the environment Special conditionsLess than 60 cm 23.6 above floor level Electrical connection Environment concernsBrown Cord clamp Blue Ecological hints Packaging materialsMachine works more economically if it is fully loaded Page 192994960 00

192994960-00-202009 specifications

Zanussi 192994960-00-202009 is a cutting-edge kitchen appliance designed to enhance the modern cooking experience. This versatile built-in oven combines efficiency with powerful cooking capabilities, making it an ideal choice for both novice cooks and seasoned chefs.

One of the standout features of the Zanussi 192994960-00-202009 is its multifunctional cooking modes. It offers a variety of settings, including conventional heating, fan-assisted cooking, grilling, and defrosting, which allows users to prepare a wide array of dishes with precision and ease. The fan-assisted cooking mode ensures an even distribution of heat, enabling perfect results for baked goods, roasts, and casseroles.

This oven also incorporates advanced technology for improved energy efficiency. With an A+ energy rating, the Zanussi model helps reduce energy consumption without compromising on performance. This is increasingly important as consumers become more environmentally conscious and seek appliances that help lower their carbon footprint.

The intuitive control panel is another key characteristic of the Zanussi 192994960-00-202009. Equipped with easy-to-use push buttons and a digital display, it simplifies the cooking process. Users can effortlessly select their desired cooking mode, adjust temperatures, and set timers, allowing for a seamless cooking experience.

Safety is paramount in kitchen appliances, and Zanussi recognizes this with features like the automatic shut-off function. This innovative safety feature ensures that the oven turns off after a set period, providing peace of mind for busy home cooks. Additionally, the oven comes with cool-touch doors, minimizing the risk of burns when opening the appliance during cooking.

Cleaning the Zanussi 192994960-00-202009 is hassle-free, thanks to the interior’s enamel finish, which prevents food residues from sticking to surfaces. This self-cleaning capability allows users to spend less time on maintenance and more time enjoying their culinary creations.

In summary, the Zanussi 192994960-00-202009 is a well-designed built-in oven that stands out for its multifunctionality, energy efficiency, and user-friendly features. Whether you are baking, roasting, or grilling, this oven promises to deliver consistent and high-quality results for all your cooking needs.
Top Page Image Contents