Switched off. Remove the laundry | Zanussi ZDC 5375 W specs

The duration value will be gradually adjusted during the execution of the drying cycle.

10.Press the START/PAUSE button. The relevant light will stop flashing. The message relevant to

	Reset/
Memory2	Off	Cotton extra dry
Memory2		Cotton extra dry
Memory1		Ready to wear
Cooling		Store dry
30 min		Slightly damp
60 min		Iron dry
Baby		Machine iron dry
Iron dry	Store dry Synthetic extra dry

Cotton extra				08.30
Cycle end at				10.55
	1200
Door	Spin	Options	Change	Exit

the phase that is in progress will be shown in the display.

If you have chosen a delayed start, the tumble dryer will begin the countdown.

Start/
Pause	Cotton extra				08.30
	Drying				10.55
		1200
	Door	Spin	Options	Change	Exit

7.Press the SPIN button repeatedly, in order to select the real spin speed that your laundry has been spun. The selected spin level will be shown on the third row above to the spin button.

Cotton extra				08.30
Cycle end at				10.55
	1200
Door	Spin	Options	Change	Exit

8.Press the «Options» button to select the required options.

To confirm your choice press the «Change» button.

Depending on the selected programme only certain options are available and shown during the selection phase.

Note: Not all the options are compatible between themselves. The incompatible option icons will disappear.

9.Select the DELAY START option if required. Before you start the programme choose the required option.

The selected delay time value (up to 20 hours) will appear on the display while selecting.

The end cycle will be updated and shown on the relative position of the display.

If the programme selector dial is turned to another position, when the machine is running, the buzzer will sound and the «Selection error» message appears in the display.

The drum turns alternately in both directions during drying.

All drying programmes end with a 10 minute cooling phase (on the second row of the display appears the «Cooling» message).

You may remove the laundry after this phase.

The display shows the following messages one after an other: «Please clean the filters» and «Please empty the tank». The buzzer sounds to indicate the end of the cycle.

11.If the laundry is not removed at the end of the cycle, the dryer performs an anti-creasingphase (duration: 30 minutes maximum).

If you do not remove the laundry, the dryer will stop automatically at the end of the anti-creasing phase. The display will show the following messages one after an other: «Anticrease», «Please clean the filters» and «Please empty the tank». The buzzer sounds to indicate the end of the cycle.

The light of the START/PAUSE button goes off and a flashing zero appears on the display.

12.Turn the programme selector dial to “RESET/ OFF”; all the lights go out. The appliance is

Delay Start
No				10.55
Door	Spin	Options	Change	Exit

Delay Start
Start in 30 min				11.25
Door	Spin	Options	Change	Exit

switched off. Remove the laundry.

If you open and then close the door before turning the programme selector dial to “RESET/OFF”, the machine is ready to perform another drying programme. The display shows the selected programme, duration of the programme and the options required.