COLD WEATHER STORAGE
The following precautions should be taken if a washer is to be stored, after use or where it would be subject to freezing conditions.
1.Turn off the water supply, then remove the inlet hoses.
2.Select a fill cycle and energize the water valve by selecting a warm water setting. A few seconds of fill is suffi- cient.
3.Disconnect from electrical supply.
4.Remove the drain hose cover from upper left corner of cabinet back.
5.Lower the drain hose to floor level and tilt washer backwards to remove water from the drain hose and pump.
6.
7.When machine is reinstalled allow machine to stabilize to room temperature. See location considerations.
FLOORING
For best performance the washer must be installed on a solidly constructed floor. Wood floors may need to be rein- forced to minimize vibration and/or unbalanced load situations. Carpeting and soft tile surfaces are contributing fac- tors in vibration and/or tendency for a washer to move slightly during the spin cycle. Never install the washer on a platform or weakly supported structure.
LOCATION CONSIDERATIONS
It is recommended the washer never be installed in areas where water may freeze since the washer will always maintain some water in the water valve, pump and hose areas. This can cause damage to belts, pump, hoses and other components. Operating temperature should be above 60°F.
ALCOVE OR CLOSET INSTALLATION
MINIMUM CLEARANCES FOR CLOSET AND ALCOVE INSTALLATIONS:
Sides – 0 in. | Rear – 1.75 in. |
Top – 19 in. | Closet Front – 0 in. |
The closet front must have a total unobstructed air opening of 72 sq. in. minimum. A louvered door with equivalent air opening is acceptable.
IMPORTANT TO INSTALLER
PLEASE READ THE PRECEDING INSTRUCTIONS CAREFULLY BEFORE STARTING TO INSTALL THE WASH- ING MACHINE. THESE INSTRUCTIONS SHOULD BE RETAINED FOR FUTURE REFERENCE.
REMOVE THE DOOR FROM ALL DISCARDED APPLIANCES TO AVOID THE DANGER OF A CHILD SUFFOCATING.
ADDITIONAL INFORMATION
50 HERTZ OPERATION
This Maytag appliance is manufactured for operation on 60 Hz AC approved electrical service. This model is not designed for use on 50 Hz AC electrical service and conversion of the product from 60 to 50 Hz operation is not recommended. For additional information on 50 Hz products, write:
MAYTAG INTERNATIONAL, INC. 1475 EAST WOODFIELD ROAD SCHAUMBURG, ILLINOIS 60173 Phone:
FOR TECHNICAL ASSISTANCE, REPLACEMENT PARTS AND ACCESSORIES
For technical assistance or if your washer requires replacement parts or accessories, contact Maytag Customer Service,
Page 4