Haier HWMP55-918 Installation and adjustment, Install the lint filter, Install the bottom plate

Installation and adjustment

Please install and adjust the machine according to the requirement of the manual. It is very important to your safety and the correct operating the machine.

Install the lint filter

After opening the package, please take out the lint
filter from the document bag, install it to the inner
tub. See the figure opposite.	Inner tub
Please ensure the lint filter is installed correctly and in
good condition to ensure the water outlet is not blocked			Lint filter
or the flow altered. If the lint filter is lost please contact
the local after -sales service department.
Install the bottom plate
The purpose of the bottom plate is to block noise
	Back
and give a quiet performance from the washing
machine during operation.
Steps:	Front
1. Lay the washer on its back.
2. Place the plate on to the bottom of the machine.
3.Use a screwdriver to tighten the screws securing		Soft object	Bottom plate
the panel to bottom of the washer.		Screw
4.Once all screws are tight and the panel is secure return
the washer to its standing position.
Adjust the position
The largest allowable slope of the	base of the machine is 2 .
Slanting or rough ground will result in unstable running or stoppage of the
machine. Please adjust it by the following method:
Confirm it is level
Adjust the adjustable leg:		2
1 .To twist the adjustable leg, please first
lift up the side of the leg slightly, loosen		adjustable nut
the adjustable nut, and twist the leg.		Fasten
	Loosen		Adjustable
2 . After adjustment, fasten the nut.		Low	feet
	High

4