How to change the direction of the drain hose
1.Dismantle the back cover of the washing machine.
2.Put down the drain hose. Take off the drainhose frame. As indicated in Figure 1, put thedrain hose into the cabinet.
Then stretch onehand into the cabinet to nip the claw of the drain hose bush- ing to remove the claw fromoriginal position. Take off the drain hose bush- ing with the other hand. (As indicated in Figure 2 and 3).
Outer drain hose
3.Dismantle the protecting cover of the drain outletat the other side (method the same as the bushing). Install the bushing as per indicated in Figure 4.
4.Extend the drain hose from the other side. Fix thedrain hose onto the base frame with the drain hoseframe. (As indicated in Figure 5)
Drain outlet protecting cover 
Drain hose frame | Drain hose bushing |
Figure 1 | Figure 2 |
Cabinet | |
Inner | Outer |
Press | Drain hose |
| bushing |
Drain hose | Take off |
bushing claw |
|
Press |
|
Drain hose bushing
Figure 4 | Figure 5 |
5.Install the protecting cover of the drain outlet at the other side as per indicated in Figure 6.
Figure 3 | Figure 6 |
|
The drain hose shall drain smoothly
1.The height of the drain hose shall be less than 10cm, or the drainage will not be smooth, and cost such long time that the machine may stop at mid way.
2.Do not ramp or press the drain hose.
3.If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of
the hose slantingly.
4.If extra drain hose is needed, please make separate purchase. The inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed 1.5m.
If the extra is too long,cut it eigher A or at B point.