GE GFDN100, GFDN110 owner manual Installing the Stack Bracket KIT, Install Bracket to Dryer

Safety Instructions

Operating Instructions

Troubleshooting Tips

GEAppliances.com

INSTALLING THE STACK BRACKET KIT

1.Remove the Dryer Leveling Legs

A. Carefully lay the dryer on its side. Use the packing material so you don’t scratch the finish on the dryer.

B.Use an open-end wrench or pliers to remove the dryer leveling legs.

Back out and remove

all 4 leveling legs

2.Install Rubber Pads to Dryer Base

Locate the 4 rubber pads in the parts package. Remove the adhesive backing and firmly place over on the bracket where you removed the leveling legs.

Consumer Support

22

3.Install Bracket to Dryer

A.Align the holes in the left bracket with the holes in the bottom left corner of the dryer. Use a Phillips screwdriver to install the 2 #12 x 1” tapping screws.

B.Repeat the above step with the right bracket on the bottom right corner of the dryer.

C.Set the dryer upright.

NOTE: Make sure to set the dryer on a piece of packing material so the brackets that are attached to

the bottom of the dryer do not damage the floor.