About the dryer control panel.
5 Dry Temp
You can change the temperature of your dry cycle.
aeruginosa and Klebsiella pneumoniae*. The
NOTE: Do not use this cycle on delicate fabrics.
*The
HIGH For regular to heavy cottons.
MEDIUM For synthetics, blends and items labeled permanent press.
LOW For delicates, synthetics and items labeled Tumble Dry Low.
EXTRA LOW For lingerie and
NO HEAT Can only be used with TIMED DRY. (on some models)
6 START
Press to start a dry cycle. If the dryer is running, press it once and it will pause the dryer.
Press it again to restart the dry cycle.
My Cycle (on some models)
Set up your favorite combination of settings and save them here for one touch recall.
These custom settings can be set while a cycle is in progress.
To store a MY CYCLE combination of settings:
1.Select your drying cycle.
2.Change DRY TEMP and SENSOR DRY LEVEL settings to fit your needs.
3.Select any drying OPTIONS you want.
4.Press and hold the MY CYCLE
pad for three seconds to store your selection. A beep will sound and the pad will light up.
To recall your stored MY CYCLE combination:
Press the MY CYCLE button before drying a load.
To change your stored MY CYCLE combination:
Follow steps
7 “CLEAN LINT FILTER” (message)
(This message represents only a reminder.)
After the POWER button is pressed, the “CLEAN LINT FILTER” message could appear if the previous cycle was not finished.
This message will disappear after the START button is pressed. Even though you have already cleaned the filter (before or after the POWER button has been pressed), the “CLEAN LINT FILTER” message will still be displayed until the START button is activated.
9
Safety Instructions
Operating Instructions
Troubleshooting Tips
Consumer Support