Stacking.
INSTALLING THE STACK BRACKET KIT (cont.)
Safety
4.Prepare the Washer and Dryer
A.Place the washer in the approximate location.
B.Make sure the washer is level. Refer to washer Installation Instructions for details.
C.Remove the back portion of the control panel by removing the 3 screws.
D.Reverse dryer door swing if desired. See dryer Installation Instructions for details.
NOTE: The washer door swing is not reversible.
Instructions
5.Install Dryer and Bracket on Washer
A.Lift the dryer on top of the washer. Be careful not to scratch the top of the washer with the brackets. Protect the washer control panel with cardboard or other protection. Be sure to lift the dryer high enough to clear the washer control panel.
B.Align the holes in the bracket with the holes in the back of the washer. Using a Phillips screwdriver, attach the 2 #8 x 1/2” tapping screws. Repeat on both sides of the washer.
Operating Instructions
WARNING!
Potential Personal Injury. More than two people are recommended to lift the dryer into position because of its weight and size. Failure to do so could result in personal injury or death.
Troubleshooting
Place hands
here
Place
hands 
here
6. Finalize the Installation
A.Refer to the washer Installation Instructions to complete the washer installation.
B.Refer to the dryer Installation Instructions to complete the dryer installation.
C.Carefully slide or walk the stacked washer and dryer into place. Use felt pads or other sliding device
to assist moving and to protect flooring.
WARNING!
Potential Personal Injury. Do not push on the dryer once installed to top of the washer. Pushing on the dryer may result in pinched fingers.
Tips
Consumer Support
23