II
Models : 8907*
|
| f |
|
S_dlage | _ capteur | Programme inimut_ | |
Normal | TimedDry | ||
Normal | S_chage _ MinLLterie | ||
HeavyDuty | _Air | Fluff | |
Grande Rendement |
| Flu× d'a# | |
PermPress |
|
| |
Perm | Press |
| Cy¢le_ _ vapeurs |
Delicates_ |
| ||
__ | Refresh | ||
D_icats |
| RaflaTdlissement | |
Sanitize_ | |||
St_riJisation |
| ||
Refresh
This cycle is best for smoothing out wrinkles and reducing odors from loads consisting of one to four dry items. In this cycle
a small amount of water is sprayed into the dryer drum after several minutes of tumbling with heat.
Touch Up
This cycle will release wrinkles from items that have been left in the dryer too long. In this cycle a small amount of water is
sprayed into the dryer drum after several minutes of tumbling with heat.
_ Overloading the dryer may not yield the same results.
Normal
Use this cycle to dry loads such as cotton, underwear, and linen.
Heavy Duty
Use this cycle to get high heat for heavy fabrics such as jeans, corduroys, or work clothes.
Perm Press
Dry
Delicates
The Delicates cycle is designed to dry
P
Sanitize
This course allows you to sanitize garments by permeating high temperature heat deep into the fabric during the drying cycle. Use this course to keep your bedding and curtains clean through
sanitization.
......................................................................................................................
Timed Dry
Time Dry allows you to select the desired cycle time in minutes.
Turn the Cycle Selector dial to Time Dry, then press the Adjust Time up arrow to set the drying time.
Press the arrow repeatedly to scroll through the time settings.
Air Fluff
The Air Fluff cycle tumbles the load in room temperature air.
16
Digital GraphicDisplay
The display window shows the estimated time remaining in the cycle after the Start/Pause button is pressed. The estimated time remaining may fluctuate as the cycle progresses.
If you select a course, the Indicator lights for the cycles to be performed are turned on. (E.g. If you select Normal, the Drying and Cooling Indicator lights are turned on.)
When the operation begins, the Indicator light of the corresponding cycle blinks and if the cycle is complete, the Indicator light is turned off.
If you press the 'Pause'button during an operation, the Indicator light that was blinking turns on permanently.
When a cycle is complete, 'END'disappears if (b 5 minutes have passed, ® the door is opened and then closed, or ® the Power button or the Start button is pressed.
Dryness Level Salec_on Button
To select the dry level in the Normal, Hea W Duty, or other Sensor Dry cycles, press the Dryness Level button. An indicator light will illuminate next to the desired dryness level.
Press the button repeatedly to scroll through the settings. Larger or bulkier loads may require the Very Dry or More Dry setting for
complete dryness.
The Less Dry setting is best suited for lightweight fabrics or for leaving some moisture in the clothing at the end of the cycle.
Use for items that lay flat or hang to dry.
O
DrynessLevel
NiV_LI de s_hage
16 | L_,_ft9:49:22 | I | |||
|
|
|