Problem | Possible cause | Remedy | |
|
| Select a different programme | |
| Wrong programme selected. | the next time you dry | |
|
| (see “Overview of pro- | |
|
| grammes” section). | |
| Lint filter clogged. | Clean lint filter. | |
| Heat exchanger clogged | Clean heat exchanger. | |
| with lint. | ||
|
| ||
Drying results unsatis- | Overloading of laundry. | Observe recommended load- | |
ing volumes. | |||
factory. |
| ||
|
| ||
| Ventilation slots in base area | Uncover ventilation slots in | |
| covered up. | base area. | |
| Residue on inside surface of | Clean inside surface of drum | |
| drum or drum ribs. | and drum ribs. | |
| Conductance of water at in- | ||
| stallation site differs from | ting for degree of drying (see | |
| standard setting of ma- | ‘Programming options’ sec- | |
| chine. | tion). | |
|
|
| |
Loading door does not | Fine strainer not in place | Install fine strainer and/or | |
and/or large mesh filter not | snap large mesh filter into | ||
close. | |||
locked in place. | place. | ||
| |||
When pressing a but- | Washing protection. After | Turn the programme knob to | |
ton, the corresponding | the start of the programme, | ||
button flashes several | the option can no longer be | OFF. Set the programme again. | |
times. | set. |
| |
| Programme selector in OFF | Turn programme selector to | |
Drum light does not | position. | LIGHT or to any programme. | |
|
| ||
work. | Defective lamp. | Replace lamp (see next sec- | |
| |||
| tion). | ||
|
| ||
Programme inactive, | Condensate tank is full. | Empty condensate tank, then | |
EMPTY WATER display | start programme with START/ | ||
illuminated. |
| PAUSE button. | |
Drying cycle ends | Not enough washing load- | Select time programme or | |
shortly after pro- | higher drying level (e.g. INTEN- | ||
ed or washing loaded is too | |||
gramme starts. END | SIVE DRY instead of STORAGE | ||
dry for selected programme. | |||
display illuminated. |
| DRY). |
20