125986421_gb.qxp 2007-09-14 09:11 Page 11
use electrolux 11
the display shows a delay of “2 hours”. After this, the delay is displayed hour by hour. The minutes or hours of delay that have been selected are displayed for 2 seconds, then the display shows the duration of the previously selected programme. The countdown begins after you have pressed the Start/Pause button. To cancel the delay time press the DELAYED START button until the display indicates 0’h. Then press the Start/Pause button again. When the delay is cancelled, the display shows the duration of the programme. During the delayed start, it is not possible to change the programme or the delay time that have been selected. To do this, you must first switch off the machine by setting the programme selector dial to “0”. Select the new pro- gramme, the options and the delayed start, then press the Start/Pause but- ton. To cancel or change options that have been selected, simply set the appliance to Pause. Once you perform the desired operation, press once again the Start/Pause button.
If you wish to add more laundry while the machine is performing the count- down, simply open the door.
When you close the door, press the Start/Pause button again to continue the countdown.
Display
The display shows the following information:
Duration of selected programme
After you have selected the programme, its duration (in hours and minutes) appears on the display. It is calculated automatically on the basis of the maximum load accepted for each type of fabric and of the required degree of drying.
1.20
GB
When the programme starts, the remaining time is displayed every 5 minutes.
Delayed start
If you have selected a delay time by means of the relevant button, the display shows it for 3 seconds; then it shows the duration of the previously selected programme. The countdown is displayed every 30 minutes until it displays “90 minutes” and then hour by hour.
3
End of programme
A flashing zero indicates the end of the programme and it is displayed after the “anticreasing” phase.
0.00
Incorrect option selection
If you select an option that is not compatible with the programme you have selected, the display shows Err (error).
This code will reappear during the execution of the programme if you press one of the option buttons or turn the programme selector.
Alarm code
In case of a functional anomaly, the display shows an alarm code (e.g. E21).