Electrolux EDE 57160W user manual Select the Start/Pause, At the end of the programme

Page 12

125986421_gb.qxp 2007-09-14 09:11 Page 12

12electrolux use

E.27

Select the Start/Pause

Press this button to start the dryer after having selected the programme and the options. The relevant light will stop flashing. If the door of the appliance or the small door at the bottom is opened while the programme is running, this button must be pressed again after closing the door in order to restart the programme from the point at which it was interrupted. In both cases the light of the Start/Pause button flashes to remind you that the start button needs to be pressed again.

Indicator lights

These lights indicate the following functions:

“Drying” light

This light indicates that the appliance is in the drying phase.

“Cooling” light

This light indicates that the appliance is in the cooling phase. At the end of drying, there is a 10 minute cooling phase to cool the laundry.

“End of programme” light

This light is on at the end of the cooling phase, during the anti-creasing phase and at the end of the programme.

“Filter cleaning” light

It comes on every 80 cycles to remind you that the condenser must be cleaned.

At the end of the programme

All drying programmes end with a 10 minute cooling phase.

If the laundry is not removed at the end of the cycle, the dryer performs an anti-creasing phase (duration: 30 min- utes maximum).

If you do not remove the laundry, the dryer will stop automatically at the end of the anti-creasing phase.

Lights end and filter remain lit and the buzzer sounds for 2 minutes.

Turn the programme selector dial to “0”; all the lights go out. The appliance is switched off.

Remove the laundry.

If you open and then close the door before turning the selector dial to “0” all the indicator lights come on.

After each use

• Clean the filters.

Important!

If the drying programme has to be

stopped before it reaches the end, we

recommend that you turn the pro-

gramme selector dial to position Cooling and wait until the end of this cooling

phase before removing the laundry. This

will avoid a build-up of heat inside the

appliance.To do this first turn the dial to

“O” and then to Cooling and depress

the Start button. Modifying the programme

To change a programme which is run- ning, first cancel it by turning the pro- gramme selector dial to “O”. Select the new programme and press the Start button .

Image 12
Contents Tumble Dryer EDE 57160W 125986421gb.qxp 2007-09-14 0911 Welcome to the world of Electrolux Contents Safety Information General safetyInstallation Child safetyUse Product description Control panel DryingCooling EndUse First Use Daily UseSelect the required programme Programme Option buttonsSelect Delay start Select DoorSelect the Buzzer Select the Quick buttonDisplay Duration of selected programmeSelect the Start/Pause At the end of the programmeDrying hints Laundry weights Maximum loadsDrying programmes Gentle Time30 min 60 minAdjusting the level of conductivity Programme informationCare and cleaning External cleaningCleaning the drum Malfunction Possible cause Solution Something not workingModel, serial number and purchase date Technical data Consumption values Programme Installation Appliance must not bulit-in UnpackingPositioning Fitting the vent hose Stacking kit Door reversalElectrical connection Permanent connection Environment concerns Packaging materialsOld machine Ecological hintsGuarantee/Customer Service Service and Spare Parts 0870 5 929125986421 01