Model, serial number and purchase date

something not working electrolux 21

Malfunction		Possible cause		Solution

When pressing a button, the corresponding button flashes several times.

Drum light does not work

●Washing protection. After the start of the programme, the option can no longer be set.

●Programme selector in OFF position.

●Defective light bulb

●Turn the programme knob to

OFF. Set the programme	GB
again

●Turn programme selector to any programme

●Replace light bulb (see next section).

Drying cycle ends shortly after programme starts. END light illuminated.

Drying cycle lasts an unusually long time. Note:

After around 5 hours the drying cycle ends automatically (see „Drying cycle complete“)

When a button is pressed, Err appears in the multi-display.

●Not enough washing loaded or washing loaded is too dry for selected programme.

●Lint filter clogged.

● button pressed and load volume too big.

●Load volume too big.

●Laundry insufficiently predrained.

●Washing protection. After the start of the programme, the

option can no longer be set.

●Select time programme or higher drying level (e.g. EXTRA DRY instead of STRONG).

●Clean lint filter

● is only suitable for use with loads of up to 3 kg!

●Reduce load volume.

●Laundry must be adequately pre-drained.

●Turn the programme knob to OFF. Set the programme again.

If you are unable to identify or solve the
problem, contact our service centre.
Before telephoning, make a note of the			IMPORTANT: if you call out an engineer
model, serial number and purchase date			to a fault listed below, or to repair a fault
of your machine: the Service Centre will			caused by incorrect use or installation, a
require this information.			charge will be made even if the
			appliance is under guarantee.
Mod.		..........
Prod. No
		Ser. No
P1206	Mod
	...........Prod. No.
		Ser. No

model, serial number and purchase date