Static problems

Trouble Shooting

Linting Problems

Is the lint bucket full? When lint reaches the top of the transparent section of the bucket it needs emptying.

Have you separated lint-shedding garments (e.g. towels) from lint receiving garments (e.g. synthetics).

Have you checked your pockets for tissues or other items that could have been left in them?

Have you over-loaded your dryer? Over-loading can result in linting problems due to reduced airflow and lint not being able to collect on the filter.

Have you over-dried your load? Over-drying can cause lint-attracting static electricity. Try a lower HOW DRY Dryness Setting or use AUTO-SENSING instead of TIME DRY.

Is the lint bucket in place?

Have your clothes been over-dried? Choose a lower dryness setting.

Items shrinking

Has the load been over-dried? Choose a lower dryness setting.

Is tumble-drying recommended? Check care labels inside garments.

If you selected TIME DRY - did you set it to dry for too long?

Has the correct temperature been used to dry the garment? Check the care label.

Clothes are creased

Does the load sit higher than the lint bucket? Your dryer is over-loaded, decrease the load size.

Did you remove your clothes as soon as the dryer was finished? Use the CREASABLES option, if you cannot return to the dryer in time.

Have your clothes been over-dried? Select a lower dryness level. Check your garments care- labels.

Drum door will not open

Refer to page 29 – Power Failure for more information, or contact your Fisher & Paykel Authorised Service Agent.

Lid will not open

Is the CREASABLES option selected? Press START/PAUSE to open the lid.