Crosley CDE-8000GW, CDE-8000GS Part 4 Accessories Installation, Uninstalling an electric dryer

Page 13

PART 4 ACCESSORIES INSTALLATION

Stacking Kit Installation Instructions(DRYER & PEDESTAL)

To ensure safe and secure installation, please observe the instructions below.

WARNING!

Incorrect Installation can cause serious accidents.

The weight of the dryer and the height of installation makes the stacking procedure too risky for one person. This procedure should be performed by 2 or more experienced service personnel.

1)Remove pedestal, installation hardware, and instructions are in the shipping carton.

2)Position dryer on top of the pedestal.

NOTE:

Because of the weight of the dryer two or more people may be needed.

If dryer was previously installed, uninstall it as follows

Refer to pedestal installation manual. (Pedestal Model : DWP-W15)

Uninstalling an electric dryer:

1Unplug the power supply cord,

2Pull the dryer away from the wall enough to loosen the vent clamp.

Loosen the clamp and carefully remove the exhaust vent from the dryer exhaust outlet.

13

Image 13

Contents

Sensor Dry Your dryer provides sensor drying and time drying programsTime Dry Specifications Table of ContentsModel Number Serial Number Date of Purchase Warranty RestrictionRead all instructions before using the appliance Important Safety InstructionsFor a permanently connected appliance For a grounded, cord-connected appliancePositioning the Dryer Part 3 Initial Steps for Installing Your DryerCloset Side View Closet DoorCloset-Front View Clean old ducts before installing this dryer Connecting the Exhaust SystemRemove screw and exhaust duct Alternate Exhaust DirectionsElectrical Plug Connections Preparation of the Dryer Procedure for Reversing the DoorConfirming Heat Source Operation Dryer AirflowPage Stacking Kit Installation InstructionsDRYER & Pedestal Part 4 Accessories InstallationUninstalling an electric dryer Instructions for Grounding of your Electric Dryer 120V/ 240V, 60 Hertz, 3-Wire InstallationImportant Warning Wire direct Wire connection Direct wire Wire connection Direct wire Option 1 4-wire connection with a power supply cord Option 3 Optional 3-wire connection Option 2 3-Wire connection with a power supply cordUse Only for Short RunInstallations Part 6 USER-MAINTENANCE InstructionsExhaust Requirements and Instructions RecommendedCleaning the Lint Screen Exhaust and Dryer MaintenancePart 7 Operating Your Dryer Select cycles designed for option Cycle Selection Power ButtonTime Change Button Status/Clean Filter/Wrinkle Care IndicatorOption Buttons Estimated Time RemainingTemp. Control Time DryDry Level Starting your dryerBeeper Start / Pause ButtonTo use a manual dry cycle Pausing or restartingProblem My Dryer Won’t Start Part 8 Troubleshooting GuideProblem My Dryer Doesn’t Heat Problem There Are Greasy Spots On My ClothesProblem There Is Static In My Clothes After Drying Problem There Is Lint On My ClothesProblem The Drying Time Is Not Consistent Problem My Clothes Are Wrinkled Problem It Takes Too Long For My Clothes To DryProblem My clothes are shrinking Page About this Manual

Related manuals

Manual 33 pages 7.71 Kb