Crosley CDE-8000GBL, CDE-8000GS, CDE-8000GW Option 2 3-Wire connection with a power supply cord

Page 19

Option 2: 3-Wire connection with a power supply cord.

lf your local codes or ordinances permit the connection of a frame-grounding conductor to the neutral wire, use these instructions.

If your local codes or ordinances do not allow the connection of a frame-grounding conductor to the neutral wire, use the instructions under Section 1: Optional 3- wire connection.

Section 1

h

Option 3: Optional 3-wire connection.

• If your local codes or ordinances do not allow the connection of a frame-grounding conductor to the neutral wire, use the instructions under this section.

1. Connect neutral wire (white) of power cord to center terminal block screw.

 

2. Connect ground wire of appliance and neutral wire

 

 

 

 

of power cord to center terminal block screw.

 

 

3. Connect red and black wires to the left and right

 

 

terminal block screws.

 

 

4. Make sure the strain relief screw is tightened. Be

 

 

sure that all terminal block nuts are on tight and

h

 

power cord is in right position.

 

h

 

5. Connect independent ground wire from external

 

ground connector to proper ground.

h

19

Page 18 Page 20
Image 19
Page 18 Page 20
Contents
Sensor Dry Your dryer provides sensor drying and time drying programsTime Dry Specifications Table of ContentsModel Number Serial Number Date of Purchase Warranty RestrictionRead all instructions before using the appliance Important Safety InstructionsFor a permanently connected appliance For a grounded, cord-connected appliancePositioning the Dryer Part 3 Initial Steps for Installing Your DryerCloset Side View Closet DoorCloset-Front View Clean old ducts before installing this dryer Connecting the Exhaust SystemRemove screw and exhaust duct Alternate Exhaust DirectionsElectrical Plug Connections Dryer Airflow Procedure for Reversing the DoorPreparation of the Dryer Confirming Heat Source OperationPage Stacking Kit Installation InstructionsDRYER & Pedestal Part 4 Accessories InstallationUninstalling an electric dryer Instructions for Grounding of your Electric Dryer 120V/ 240V, 60 Hertz, 3-Wire InstallationImportant Warning Wire direct Wire connection Direct wire Wire connection Direct wire Option 1 4-wire connection with a power supply cord Option 3 Optional 3-wire connection Option 2 3-Wire connection with a power supply cordRecommended Part 6 USER-MAINTENANCE InstructionsUse Only for Short RunInstallations Exhaust Requirements and InstructionsCleaning the Lint Screen Exhaust and Dryer MaintenancePart 7 Operating Your Dryer Select cycles designed for option Cycle Selection Power ButtonEstimated Time Remaining Status/Clean Filter/Wrinkle Care IndicatorTime Change Button Option ButtonsTemp. Control Time DryStart / Pause Button Starting your dryerDry Level BeeperTo use a manual dry cycle Pausing or restartingProblem There Are Greasy Spots On My Clothes Part 8 Troubleshooting GuideProblem My Dryer Won’t Start Problem My Dryer Doesn’t HeatProblem There Is Static In My Clothes After Drying Problem There Is Lint On My ClothesProblem The Drying Time Is Not Consistent Problem My Clothes Are Wrinkled Problem It Takes Too Long For My Clothes To DryProblem My clothes are shrinking Page About this Manual
Related manuals
Manual 33 pages 7.71 Kb