8Maintenance and cleaning
Cover filter
Lint and fibres released from the laundry to the air during the drying cycle are collected in the “Cover Filter”.
CSuch fibre and lint are generally formed during wearing and washing.
C Always clean the filter after each Drying process.
C You can clean the filter and filter area by vacuum cleaner.
For Filter cleaning;
1 Take out the cover
2Remove the cover filter by pulling it up and open the filter.
3Clean lint, fibre, and cotton raveling by hand or with a soft piece of cloth.
4Close the filter and place it back into its seat.
Sensor (models equipped with a sensor)
There are humidity sensors in your machine that detect whether the laundry is dry or not.
For sensor cleaning;
1 Open the cover of your machine.
2Allow the machine to cool off if drying has been carried out.
3Wipe the metal sensors with a soft cloth, dampened with vinegar and dry
them.
CClean metal sensors 4 times a year.
ANever use solvents, cleaning agents or substances alike when cleaning as these might cause fire and explosion!
Water tank (Products equipped with a condenser);
The moisture in the damp laundry is taken from the laundry and condensed. Drain the water tank after each drying cycle or during drying when “Water tank” warning LED comes on.
A Condensed water is not drinkable!
CYou can use the water in the water tank in your steam irons or air humidifiers.
ANever take out the water tank when the programme is running!
Water tank may be located in two different places as indicated below, depending on the model of your machine.
-Inside the drawer on the panel
-Inside the kick plate cover
If you forget to drain the water tank, your machine will stop during the following drying cycles when the water tank is full and the “Water tank” warning LED will light on. If this is the case, press the “Start/Pause/Cancel” button to resume the drying cycle after draining the water tank.
In order to drain the water tank;
1Carefully remove the water tank by opening the kick plate cover/pulling the drawer.
2Drain the water by opening the water tank cover.
3If there is lint accumulation in the water tank cover, clean it and press to close.
4 Place the water tank into its seat.
20 - EN