Adding/removing laundry in standby mode
In order to add or take out laundry after the
1.Press the “Start/Pause/Cancel” button to switch the machine to “Pause” mode. Drying process will stop.
2.Open the door at Pause position and close it again after adding or taking out laundry.
3.Press “Start/Pause/Cancel” button to start the programme.
C Any laundry added after the drying process was started may cause the already dried clothes in the machine intermingle with wet clothes and the result will be wet laundry after the drying process is over.
C Laundry may be added or taken out as much as desired during a drying process, but as this process will interrupt drying continuously, it will extend the programme duration and increase energy consumption. Therefore, it is recommended to add laundry before the drying programme is started.
Child-proof lock
There is a childproof lock to prevent any programme interruption due to the pressing of keys while the programme is on. The loading door and all keys except the “On/Off” key on the panel are deactivated when the
In order to activate the childproof lock, press on the “Start/Pause/Cancel” and “Cancel audio
warning” buttons
simultaneously for 3 seconds.
To start a new programme after the programme is over or to interrupt
the programme, the childproof lock should be deactivated. To deactivate the childproof lock, press the same buttons for 3 sec.
C 2 beeps when activating and 1 beep when deactivating the
Ending the programe through canceling
The programme which is selected first will keep on going even if the position of the programme selection button is changed. A new programme can be selected and started after “Programme cancel” is activated in order to change the drying programme.
To cancel any selected programme;
•Press “Start/Pause/Cancel” button for about a duration of 3 seconds. The “Filter cleaning”, “Water tank” and “End/ Anti- creasing” warning LEDs will light up at the end of this period for reminding purposes.
A As the inside of the machine will be excessively hot when you cancel the programme while the machine is running, activate the ventilation programme to cool it down.
AIf the machine is stopped during any drying programme, and if the position of the programme selection knob is changed, an audio signal will be heard (if the “Cancel audio warning” function is not selected).
The machine will not start even if the “Start/Pause/Cancel” button is pressed, unless the programme selection knob is returned to the initial programme. The paused programme must be cancelled in order to change the drying programme.
17 - EN