Beko DCU 7230 Electrical Connection, Electrical requirements, This appliance must be earthed

Page 10

4Electrical Connection

Make sure that you have an earthed power outlet socket rated at 13 amps (minimum).

Attention!

If you use your dryer as built-in, the socket must be reachable after installation, or a separate switch (which can disconnect the two poles) must be used in the installation. Check for suitability.

For a permanent connection, a master switch with at least 3mm contact clearance and minumum 13 A rating must be used.

Electrical requirements

Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating label corresponds to your electricity supply. We recommend that this appliance be connected to the mains supply via a suitable switched and fused socket in a readily accessible position.

Should the mains lead of the appliance become damaged or need replacing at any time, it must be replaced by a special purpose made mains lead which can only be obtained from a Authorised Service Agent.

AWarning

This appliance must be earthed

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted.

The moulded plug on this appliance incorporates a 13A fuse. Should the fuse need to be replaced an ASTA approved BS1362 fuse of the same rating must be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover, the plug must not be used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are available from any good electrical store.

In order to avoid hazards, damaged supply cord should be replaced by the manufacturer, its service agent or similarly qualified people.

Built-under installation

This appliance can be installed under a worktop.

AUndercounter installation without the top cover must only be carried out by an authorised agent.Risk of electric shock.

A Important

Fitting a different plug

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals on your plug, proceed as follows:

1 Connect the green - yellow or green (earth) wire to the terminal in the plug marked ‘E’ or with the symbol or coloured green and yellow or green.

2 Connect the blue (neutral) wire to the terminal in the plug marked ‘N’ or coloured black.

3 Connect the brown (live) wire to the terminal in the plug marked ‘L’ or coloured red.

With the alternative plugs a 13A fuse must be fitted either in the plug or adaptor or in the main fuse box. If in doubt contact a qualified electrician.

Green and yellow

or green

N

L

Blue or black

Brown or red

 

Washer/dryer combination

Do not stack washing machine on top of the tumble dryer. This would damage both appliances and guarantees would become void. It is also unsafe to stack an appliance on top of another without using a suitable and approved stacking kit obtained from the manufacturer of the appliances.

10

EN

Image 10 Contents
DCU Explanation of symbols Read this manual prior to initial operation of the productTable of Contents Overview Kick plate opening tab Fluff filter Adjustable feetYour Dryer Control panelTechnical Specifications General safety Important safety instructions Do not use electrical devices in the product Children’s safety Intended useInstallation Disposing of packaging material Adjusting the feetFirst use Transportation of the machineThis appliance must be earthed Electrical ConnectionElectrical requirements Fitting a different plugLaundry suitable for drying in the machine Initial preparations for dryingThings to be done for energy saving Laundry unsuitable for drying in the machinePreparing laundry for drying Following weights are given as examplesCorrect load capacity Selecting a Programme and OperatingYour Machine Control panelPreparing the machine 1. Plug in your machine Programme selectionProgramme selection and consumption table Cottons / ColoredsStarting the programme Time delayAuxiliary function Progress of programmeAdding/removing laundry in standby mode Finishing by cancelling the programmePress Start/Pause/Cancel button to start the programme Child-proof lockEnd of programme 18 ENSensor Maintenance and cleaningFilter Cartridge / Door Inner Surface Water tankProgramme is running For the condenserPlace the water tank into its seat Page Suggested solutions for problems What is not covered? GuaranteeWhat is covered? Important notesRepublic of Ireland ServiceService once the manufacturers guarantee has expired UK Mainland & Northern IrelandPage Page