Beko DCU 7230 Maintenance and cleaning, Filter Cartridge / Door Inner Surface, Sensor, Water tank

CSuch fibre and lint are generally formed

Sensor

during wearing and washing.

C Always clean the filter and the inner

surfaces of the cover after each drying

process.

C You can clean the filter and filter area by

vacuum cleaner.

To clean the filter:

1. Open the loading door.

2. Remove the cover filter by pulling it up

and open the filter.

3. Clean lint, fibre, and cotton by unravelling

by hand or with a soft piece of cloth.

4. Close the filter and place it back into its

seat.

There are humidity sensors in your dryer that

C Clogging may arise on the filter surface

after using your machine for some time;

detect whether the laundry is dry or not.

To clean the sensor:

if this occurs, wash the filter with water

1. Open the loading door of the dryer.

and dry it before using again.

2. Allow the machine to cool down if drying

has been carried out.

3. Wipe the metal sensors with a soft cloth,

dampened with vinegar and dry them.

C Clean metal sensors 4 times a year.

A Never use solvents, cleaning agents

or similar substances when cleaning

since these materials can cause fire and

explosion!

Water tank;

The moisture in the damp laundry is taken

C Clean the entire inner surface of the

from the laundry and condensed. Drain the

door and door gasket by wiping with a

water tank after each drying cycle or during

damp cloth.

drying when “Water tank” warning light turns

on.

A Condensed water is not drinkable!

A Never take out the water tank when the

19

EN