Blomberg Comprehensive Dryer Manual for Troubleshooting and Solutions

7Troubleshooting

Problem	Cause	Explanation / Solution
Drying process	Lint filter may not have been	* Clean the lint filter.
		* Meshes of the filter may be
takes too long.	cleaned.
		clogged. Wash with water.
	* It may not plugged in.	* Make sure that the dryer is
		plugged in.
Dryer does not	* The loading door may be ajar.
		* Make sure the loading door is
switch on or the	* Program may not be set or the
		properly closed.
program does not	“Start/Pause/Cancel” button may
		* Make sure the program has been
start. Dryer does	not have been pressed.
		set and it is not in “Pause” mode.
not start when set.	* “Childproof lock” may be activated.
		* Deactivate the childproof lock.
Program is		* Make sure the loading door is
	* The loading door may be ajar.	properly closed.
interrupted for no
	* Electricity may be cut off.	* Press the “Start/Pause/Cancel”
reason.
		button to start the program.
		* Dry only the laundry which is
Laundry has		suitable for drying in the dryer. First
shrunk, become	* A program not suitable for the	check the labels on the clothes.
felted or has	laundry type might have been used.	* Select a program a suitable low
deteriorated.		temperature setting for the laundry
		type to dry the clothes.
“End / Anticrease”	* The 2-hour anti creasing program	* Turn off the dryer and take the
	to prevent laundry from wrinkling
LED flashes.	may have been activated.	laundry out of the dryer.
“End / Anticrease”	* Program has come to an end.	* Turn off the dryerand take the
LED is on.		laundry out of the dryer.
“Filter cleaning”	* Lint filter may not have been	* Clean the lint filter.
		* Meshes of the filter may be
LED flashes.	cleaned.
		clogged. Wash with water.
The “Drying” LED	* A heat sensor failure has occurred.	* Turn off the dryer and remove the
flashes.	dryer ends the program without	laundry. Call the authorized service.
	heating.

A Call an authorized service if the problem persists.

23 - EN