Starting the Program
1.Press the “Start/Pause/Cancel” button to start the program.
2.The Start/Pause/Cancel button will light up to indicate that the program has started.
Progress of program
Progress of a running program is shown through the program
“Drying”:
-Drying level will be illuminated during the whole drying process until the dryness reaches “Damp Dry / Ready to Iron”.
“Damp Dry / Ready to Iron”:
-Lamp lights when the dryer reaches the
“Damp Dry / Ready to Iron” step and remains lit until the next step.
“Regular Dry / Ready to Wear”:
-Lamp lights when the dryer reaches the
“Regular Dry / Ready to Wear” step and remains lit until the next step.
“End / Anticrease”:
-The lamp lights when the program comes to an end and the
C If more than one lamp lights or flashes constantly, it means that there is a malfunction or a failure (Please see Troubleshooting).
Changing the program after the program has started
Press and hold the Start/Pause/Cancel button for around 3 seconds to Cancel the program currently running.
Select another program by rotating the program knob.
Press the “Start/Pause/Cancel” button again to start the new program.
C The program which is selected first will go on even if the program selector knob is moved and another program is selected while the dryer is operating. You must cancel the current program to change the drying program.
AAs the inside of the dryer will be excessively hot when you cancel the program when the dryer is running, activate the
ventilation program to cool it down.
A If the dryer is stopped during any drying program, and if the position of the program selector knob is changed, a tone will be heard (if the Cancel Audio Warning function is not selected). The dryer will not start even if the Start/Pause/Cancel button is pressed, unless the program selector knob is returned to the initial program. The paused program must be cancelled in order to change the drying program.
Adding/removing laundry in stand-by mode
In order to add or take out laundry after the start of the program;
1.Press the Start/Pause/Cancel button to switch the dryer to Pause mode. the drying process will stop.
2.Open the door at the Pause position and close it again after adding or taking out laundry.
3.Press the “Start/Pause/Cancel” button to restart the program.
CLaundry may be added or taken out during a drying process, but interrupting drying continuously will extend the program's time and increase energy consumption. Therefore, it is recommended to add all laundry before the drying program is started.
Auxiliary functions
Cancel Audio Warning Signal
Your dryer will send out a tone when the program comes to an end. If you do not want to hear this, you need to press the Cancel Signal button. The relevant lamp will light when this button is pressed and the tone will not activate when the program ends.
C You can select this function either before or after the program starts.
Child-proof lock
There is a childproof lock to prevent any program interruption due to the pressing of keys while a program is running. The loading door and all buttons except the “On/Off” key on the panel are deactivated when the child- proof lock is active.
In order to activate the childproof lock, pres the Start/Pause/Cancel and Cancel Audio Warning buttons at the same time for 3 seconds.
To start a new program after the program ends or to stop a program, the childproof
18 - EN