There are dampness sensors in the machine that detect whether the laundry is dry or not.
To clean the sensors:
1. Open the loading door of the machine.
2. Allow the machine to cool down if it is
still hot due to the drying process.
3. Wipe the metal surfaces of the sensor with a soft cloth, dampened with vinegar and dry them.
C Clean metal surfaces of the sensors 4 times a year.
C Do not use metal tools when cleaning metal surfaces of the sensors.
ANever use solvents, cleaning agents or similar substances for cleaning due to the risk of fire and explosion!
Draining the water tank
Dampness of the laundry is removed and condensed during drying process and the water that arise accumulates in the water tank. Drain the water tank after each drying cycle.
ACondensed water is not potable! ANever remove the water tank when
the programme is running!
If you forget to drain the water tank, the machine will stop during the subsequent drying cycles when the water tank is full and the Water Tank warning symbol will flash. If this is the case, drain the water tank and press Start / Pause / Cancel button to resume the drying cycle.
To drain the water tank:
1.Pull the drawer and remove the water tank carefully.
2. Drain the water in the tank.
3.If there is lint accumulation in the funnel of the water tank, clean it under running water.
4.Place the water tank into its seat.
Cleaning the filter drawer
Lint and fibre that could not be captured by the lint filter are blocked in the filter drawer behind the kick plate. Filter Drawer Cleaning warning light will light up maximum at every 5 drying cycles as a reminder.
There is a
To clean the filter drawer:
1.Press the kick plate button to open the kick plate.
25
EN