Blomberg TKF 8451 SGC 50, TKF 8451 A 50 Mounting over a washing machine, Connecting to the drain

ANever operate the dryer without the top trim is in place.

Dryer Depth	60 cm	54 cm
Stock
number of
under-bench	2979600100	2973600100
installation
part

•Leave at least 3 cm of space around the sides and the rear wall of the product when installing it under a counter or in a cupboard.

Mounting over a washing machine

•A fixing device should be used between the two machines when installing the dryer above a washing machine. The fixing device

(2977200100 white/2977200400 grey) must be installed by the Authorized Service Agent.

•Total weight of the washing machine and the dryer -with full load- when they are placed on top of each other reaches to approx. 180 kilograms. Place the products on a solid floor that has sufficient load carrying capacity!

Connecting to the drain

In products equipped with condenser unit, water accumulates in the water tank during the drying cycle. You should drain accumulated water after each drying cycle.

You can directly drain accumulated water through the water drain hose supplied with the product instead of periodically draining the water collected in the water tank.

Connecting the water drain hose

1. Pull hose in the product by hand in order to disconnect it from where it is connected. Do not use any tools to remove the hose.

2. Connect one end of the drain hose supplied separately with the product to the connection point from where you removed the hose of the product in previous step.

3. Connect the other end of the drain hose directly to the wastewater drain or to the washbasin.

AHose must be fixed in every type of connection. Your house will be flooded if the hose comes loose

during water discharge.

C Water drain hose should be attached

7 EN