Beko DC 7100 Electrical Connection, Built-under installation, Fitting a different plug, 10 EN

Page 10

4Electrical Connection

Make sure that you have an earthed power outlet socket rated at 13 amps (minimum).

Attention!

When installed, the socket must be reachable after installation, or a separate switch (which can disconnect the two poles) must be used in the installation. Check for suitability.

For a permanent connection, a master switch with at least 3mm contact clearance and minumum 13 A rating must be used.

Electrical requirements

Before you insert the plug into the wall socket make sure that the voltage and the frequency shown in the rating label corresponds to your electricity supply.

We recommend that this appliance be connected to the mains supply via a suitable switched and fused socket in a readily accessible position.

Should the mains lead of the appliance become damaged or need replacing at any time, it must be replaced by a special purpose made mains lead which can only be obtained from a Authorised Service Agent.

AWarning

This appliance must be earthed

If the fitted moulded plug is not suitable for your socket, then the plug should be cut off and an appropriate plug fitted.

The moulded plug on this appliance incorporates a 13A fuse. Should the fuse need to be replaced an ASTA approved BS1362 fuse of the same rating must be used. Do not forget to refit the fuse cover. In the event of losing the fuse cover, the plug must not be used until a replacement fuse cover has been fitted. Colour of the replacement fuse cover must be the same colour as that visible on the pin face of the plug. Fuse covers are available from any good electrical store.

In order to avoid hazards, damaged supply cord should be replaced by the manufacturer, its service agent or similarly qualified people.

Built-under installation

This appliance can be installed under a worktop.

ADo not operate without the top cover fitted. Risk of injury.

A Important

Fitting a different plug

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals on your plug, proceed as follows:

1 Connect the green - yellow or green (earth) wire to the terminal in the plug marked ‘E’ or

with the symbol or coloured green and yellow or green.

2 Connect the blue (neutral) wire to the terminal in the plug marked ‘N’ or coloured black.

3 Connect the brown (live) wire to the terminal in the plug marked ‘L’ or coloured red.

With the alternative plugs a 13A fuse must be fitted either in the plug or adaptor or in the main fuse box. If in doubt contact a qualified electrician.

Green and yellow

or green

N

L

Blue or black

Brown or red

 

Washer/dryer combination

Do not stack washing machine on top of the tumble dryer. This would damage both appliances and guarantees would become void. It is also unsafe to stack an appliance on top of another without using a suitable and approved stacking kit obtained from the manufacturer of the appliances.

A special stacking kit is required as an optional extra please contact customer service.

10 EN

Image 10
Contents Condenser Time Dryer Explanation of symbols Read this manual prior to initial operation of the productTable of Contents Your Dryer OverviewTechnical Specification Important safety information General safetyChildren’s safety Intended useInstallation First useTransportation of the machine Disposing of the old machineFitting a different plug Built-under installationElectrical Connection Washer/dryer combinationLaundry suitable for drying in the machine Initial preparations for dryingThings to be done for energy saving Laundry unsuitable for drying in the machineLoading Preparing laundry for dryingCorrect load capacity 12 ENControl panel Selecting a Programme and OperatingYour Machine13 EN Preparing the machine Timer programme selection14 EN Programme selection and consumption table 15 ENAdding/removing laundry in standby mode Auxiliary function Low temperatureTimer follow-up indicator Ending the programme through cancelingEnd of programme 17 ENFilter Cartridge / Door Inner Surface Maintenance and cleaningWater tank 18 ENFor the condenser 19 ENSuggested solutions for problems 20 ENWhat is not covered? GuaranteeWhat is covered? Important notes22 EN ServiceService once the manufacturers guarantee has expired Republic of Ireland