Bosch Appliances WTA 3510, WTL 5410 manual Builtin Installation

Page 18

23 5/8''

(600 mm) minimum

231/4''

(590 mm)

33 1/2''

(850 mm) minimum

Figure 13.

Built￿in Installation

The Bosch dryer can be built-in: that is, you can install the Bosch dryer under-counter in a kitchen cabinet opening. The cabinet opening should be square and have the dimensions as shown in Figure 13.

Note: If installed under a countertop, the countertop must be continuous and securely attached to neighboring cabinets.

￿WARNING

DO NOT install the dryer in an area where gasoline or other flammable materials are kept or stored.

The dryer must be installed in a room that is adequately ventilated. Make sure there is an adequate supply of fresh air. Both the WTA 3510, electric vented dryer, and the WTL 5410, electric condensation dryer need an adequate supply of fresh air for optimum performance.

CAUTION

DO NOT install the dryer in a closet with a solid door. The dryer must have make up air as specified on page 17 under Ventilation Requirements.

18

Image 18
Contents WTA Electric Vented Dryer Page Installer Keep These Instructions for Future ReferenceImportant Safety Instructions Important Safety Instructions Grounding InstructionsAbout Your Dryer Getting to Know Your DryerOperating Tips Before Using for the First TimeEnergy Saving Tips Getting StartedRO UO R Cycle Selection Chart RecommendationsOperation Turn the dryer onSelect the Drying Cycle Desired Add Fabric Softener Sheet, if desiredClose the Door To use Electronic Auto Dry Cycles``End of Cycle Signal Select Additional FUNCTIONS, if desired``Delicates Care and Cleaning Lint FilterHeat Exchanger WTL models only Moisture Sensor Service and Repair800/944-2904 Frost Protection WTL models onlySELF-HELP Statement of Warranties Bosch Clothes Dryers ExclusionsParts Needed for Installation Model WTA 3510 only Tools Needed for InstallationParts Supplied for Installation IntroductionVenting Additional Grounding ProcedureElectrical Receptacle DuctworkTechnical Data Builtin Installation Step Unpack the Dryer InstallationStep Position Dryer near Installation Area Step Inspect the DryerRigid Duct Flexible Duct Checking/Installing Exhaust DuctingMaximum length of duct StepStep Electrical Electrical Connection, 4-WireElectrical Connection, 3-Wire To Change CordStep Position and Level the Dryer Step Connect Duct System to Dryer Model WTA 3510 only Step Final Check List1101 en 5550 006