LGround
Figure 20.
11.Check the nut on the U.L. strain relief clamp to make sure that it is tight and the strain relief clamp cannot turn.
12.Replace the cover on the junction/splitter box and fasten in place.
The dryer is now ready to be plugged into the
Note: The receptacle should be located so that the plug and receptacle will be accessible with the dryer in its installed position.
Additional Grounding Procedure
Some local codes may require a separate ground. In such cases, the required accessory ground wire, clamp and screw must be purchased separately. Never ground the dryer to plastic plumbing lines, gas lines or hot water pipes.
Step 7
Position and Level the Dryer
Place the dryer in position on a clean, level, solidly constructed floor. Installation on any type of carpeting is not recommended.
With dryer in position, it must then be leveled. Check dryer, using level as shown in Figure 21.
CAUTION
Do not slide dryer across the floor if leveling legs have been extended. Legs and/or dryer base may be damaged if dryer is slid across floor with leveling legs extended.
Figure 21.
22