Bosch Appliances WTL 5410 manual Step Connect Duct System to Dryer Model WTA 3510 only

Page 23

The dryer should be level with all four feet firmly on the ground. The dryer must not wobble.

If the dryer is not level or if it does wobble, the legs must be adjusted. Refer to Figure 22. Adjust the leveling legs until the dryer does not rock and is level, both front-to-back and side-to-side.

Figure 22.

Step 8

Connect Duct System to Dryer (Model WTA 3510 only!)

Connect the exhaust ducting system to the dryer exhaust outlet.

Step 9

Final Check List

1.Review the electrical requirements (and for WTA model the exhaust requirements) and steps 1 through 8 to make sure they were performed properly.

2.Make sure the electrical supply is on.

3.Read the Use and Care Manual to fully understand how your dryer operates. Turn on the dryer. Select the ``Heated Dry'' cycle and let the dryer run for 2±5 minutes.

4.After 2±5 minutes stop the dryer and open the door. You should feel heat inside the dryer.

5.If the dryer does not operate, refer to the SELF-HELP and the SERVICE and REPAIR sections of the Use and Care Manual.

6.Upon completing check, turn dryer off.

7.LEAVE INSTALLATION INSTRUCTIONS AND USE AND CARE MANUAL WITH OWNER.

23

Image 23
Contents WTA Electric Vented Dryer Page Keep These Instructions for Future Reference InstallerImportant Safety Instructions Grounding Instructions Important Safety InstructionsGetting to Know Your Dryer About Your DryerGetting Started Before Using for the First TimeEnergy Saving Tips Operating TipsTurn the dryer on Cycle Selection Chart RecommendationsOperation RO UO RTo use Electronic Auto Dry Cycles Add Fabric Softener Sheet, if desiredClose the Door Select the Drying Cycle Desired``Delicates ``End of Cycle SignalSelect Additional FUNCTIONS, if desired Heat Exchanger WTL models only Care and CleaningLint Filter Frost Protection WTL models only Service and Repair800/944-2904 Moisture SensorSELF-HELP Exclusions Statement of Warranties Bosch Clothes DryersIntroduction Tools Needed for InstallationParts Supplied for Installation Parts Needed for Installation Model WTA 3510 onlyDuctwork Additional Grounding ProcedureElectrical Receptacle VentingTechnical Data Builtin Installation Step Inspect the Dryer InstallationStep Position Dryer near Installation Area Step Unpack the DryerStep Checking/Installing Exhaust DuctingMaximum length of duct Rigid Duct Flexible DuctTo Change Cord Electrical Connection, 4-WireElectrical Connection, 3-Wire Step ElectricalStep Position and Level the Dryer Step Final Check List Step Connect Duct System to Dryer Model WTA 3510 only1101 en 5550 006