ENERGY SAVING TIPS
To save energy, time and money, Bosch recommends the following:
Always spin dry the laundry in the washer at the highest recommended speed for the fabric type. The highest spin speed will result in a dryer load and shorten the drying time and amount of energy required to dry the load.
Spin dry delicate washing before tumble drying.
Load the dryer properly. Do not exceed the maximum load (see CYCLE SELECTION CHART).
Always clean the lint filter after each use of the dryer.
OPERATING TIPS
Follow the fabric care labels on the clothing.
Avoid very small loads. When only one or two items need drying, add a few similar items to improve drying efficiency.
Do not mix heavyweight and lightweight clothing.
Do not dry wool or fabrics with a wool content
Do not dry fabrics that do not allow the free passage of air (for example, GORETEX)
Do not dry delicate fabrics such as, silk, synthetic net curtains, etc.
BEFORE USING FOR THE FIRST TIME
Before beginning to use your dryer for the first time:
1.Check to make sure that the voltage on which the dryer is to operate is the same as shown on the rating plate.
2.Wipe the interior of the drum with a damp cloth.
3.Thoroughly inspect the dryer for cosmetic damage.
GETTING STARTED
Below, in order to get started, you will find a summary of how to operate the clothes dryer. Also, refer to the CYCLE SELECTION CHART, Table 1.
Turn On the Dryer
Press the ``On/Off'' button. The indicator light will become illuminated and the indicator above the `Start'' button will begin to flash.
Check the Lint Filter
The lint filter, located in the door, should be cleaned after or before each load.
Load the Dryer
Load the items in the dryer.
Add Fabric Softener Sheet
If a fabric softener sheet is to be added it should be done after loading the dryer.
Close the Dryer Door
Select Cycle Desired
See CYCLE SELECTION CHART, Table 1, and following section titled OPERATION for program recommendations.
Select Additional Functions (if desired) See following section titled OPERATION.
Press the `Start'' Button
The `Start'' indicator lamp will stop flashing and the dryer will start. If one of the
The cycle will continue to the end, when the ``End'' indictor lamp will become illuminated. And, if the ``End of Cycle Signal'' has been selected a signal will sound. ± See following section OPERATION on how to set or turn of the ``End of Cycle'' signal.
Depress the ``Door'' Button The door will open.
Remove the Laundry from the Dryer
Clean the Lint Filter
Turn Off the Dryer
Depress the ``On/Off'' button.
7