Alliance Laundry Systems TMB1276C manual Contrast/Backlight Menu, Close Door Menu

Page 15

Contrast/Backlight Menu

Contrast	Backlight
Contrast / Backlight Menu
	PHM1008R

Figure 7

Press the keypad from Cycle Menu or Run Menu to enter the Contrast Adjust/Backlight Menu. The Contrast Adjust/Backlight Menu allows the user to adjust contrast and turn the backlight on or off.

Press the or keypad to highlight “Contrast” or “Backlight” menu items.

Once the menu item has been selected, press the

or keypad to change contrast. The backlight is either on or off and will have a factory default of on.

Press the keypad to enter the previous page.

If the Contrast Adjust/Backlight Menu is selected from

the Run Menu and the keypad is pressed, the cycle is stopped.

Machine Cycle Definition and Operation

Close Door Menu

TMB1303R

Figure 8

The Close Door Menu displays when loading door or lint door on the machine is open and needs to be closed.

Close door or press the keypad to return to Cycle Menu.

70444801

Image 15

Contents Tumble Dryer Page Contents Modify Cycle Segment Menu Navigation Auto Ignition Retry Gas Models Only Air Flow Switch Errors Introduction Model IdentificationNameplate Location Communications Power Failure RecoveryPreliminary Information About the ControlIR Communications Menu IR Communications Error MenuRestore to Factory Defaults Entering Program ModeOperational Keypad UniLinc IdentificationOperation Modes Entering Diagnostic Mode From Idle Mode End of Cycle ModeExtended Tumble Mode Reversing Mode reversing models only Cycle Menu Machine Cycle Definition and Operation Rotation Sensor Equipped Machines Machine Cycle OperationTo Start a Cycle Run Menu 3000Close Door Menu Contrast/Backlight MenuTemp Run Diagnostic MenuCycle01 Towels Moisture Dry Cotton Segment01 0500 Temp and Moisture MenuError Menu Cycle Stopped MenuPress Stop Key to Abort Cycle Load Sensed Menu Clean Lint Screen MenuService Moisture Sensor Menu Open Door MenuUniLinc Menu NavigationSystem Menu Map Tree Display Screen MapsRun Menu Map Tree Service Menu Map TreeProgramming UniLinc System MenuSave Changes Menu Program Menu Program MenuModify Cycle Available Characters Modify Cycle Segment Menu Navigation Cycle, Segment and Step Programming Flow DiagramBanners Global SetupGlobal Setup Menu Language MenuDay of Week Date/Time MenuBanners Menu Current DateAudio Menu Key Pad End of Cycle VolumeTime External Signal Enable Rapid Advance MenuIgnition Retry Menu Miscellaneous MenuReverse Cylinder Menu if equipped Temperature MenuTime TemperatureCool Down Menu Moisture Menu if equippedFactory Defaults Menu TemperaturesOnly Test Menu DiagnosticsDiagnostic Menu Diagnostics Are DisabledStep Advance Comments Test Cycle ChartInputs Outputs Menu 3029Machine ID Menu Alarms MenusMachine Errors Air Flow Switch Errors Rotation Sensor ErrorAuto Ignition Retry Gas Models Only DIP Switch/Harness Index Mismatch Error Moisture Sensor ErrorFan Motor Contactor Error Fan Motor Centrifugal Switch ErrorLaundry Management Menus Laundry ManagementService Schedule Menu Daily Menu ServiceMonthly Menu Service Quarterly Menu Service Bi-Annual Menu Service Quarterly Maintenance RemindersOFF Cycle Charts