Alliance Laundry Systems TMB1276C manual Quarterly Maintenance Reminders

Page 43

Maintenance

Quarterly Menu (Service)

Bi-Annual Menu (Service)

Quarterly Maintenance Reminders:

1.Use a vacuum to clean air vents on drive motors.

2.Use a vacuum to clean lint from rear limit thermostat cover.

3.Check flow of combustion and ventilation air.

4.Check belt tension and condition. Replace worn or cracked belts.

Service Schedule

TMB1337R

Figure 54

The Quarterly Menu contains all service reminders that need to be performed four times a year.

Press the keypad to return to Service Menu.

Bi- Annual Maintenance Reminders:

1.Check mounting hardware for any loose nuts, bolts, or screws.

2.Check gas steam connections for leakage.

3.Check loose electrical connections.

4.Remove all front panels and vacuum.

5.Check cylinder and front panel seals.

6.Inspect cabinet and inner panels for any damage, replace or repair as needed.

7.Clean burner tubes of any lint buildup.

Service Schedule

TMB1338R

Figure 55

The Bi-Annual Menu contains all service reminders

that need to be performed twice a year. Press the keypad to return to Service Menu.

70444801

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

41

Image 43
Contents Tumble Dryer Page Contents Modify Cycle Segment Menu Navigation Auto Ignition Retry Gas Models Only Air Flow Switch Errors Model Identification IntroductionNameplate Location Communications Power Failure RecoveryPreliminary Information About the ControlIR Communications Menu IR Communications Error MenuRestore to Factory Defaults Entering Program ModeOperational Keypad UniLinc IdentificationOperation Modes Entering Diagnostic Mode From Idle Mode End of Cycle ModeExtended Tumble Mode Reversing Mode reversing models onlyCycle Menu Machine Cycle Definition and OperationRotation Sensor Equipped Machines Machine Cycle OperationTo Start a Cycle Run Menu 3000Close Door Menu Contrast/Backlight MenuTemp Run Diagnostic MenuCycle01 Towels Moisture Dry Cotton Segment01 0500 Temp and Moisture MenuCycle Stopped Menu Error MenuPress Stop Key to Abort Cycle Load Sensed Menu Clean Lint Screen MenuService Moisture Sensor Menu Open Door MenuUniLinc Menu NavigationSystem Menu Map Tree Display Screen MapsRun Menu Map Tree Service Menu Map TreeSystem Menu Programming UniLincSave Changes Menu Program Menu Program MenuModify Cycle Available Characters Modify Cycle Segment Menu Navigation Cycle, Segment and Step Programming Flow DiagramBanners Global SetupGlobal Setup Menu Language MenuDay of Week Date/Time MenuBanners Menu Current DateAudio Menu Key Pad End of Cycle VolumeTime External Signal Enable Rapid Advance MenuIgnition Retry Menu Miscellaneous MenuReverse Cylinder Menu if equipped Temperature MenuTime TemperatureCool Down Menu Moisture Menu if equippedTemperatures Factory Defaults MenuOnly Test Menu DiagnosticsDiagnostic Menu Diagnostics Are DisabledStep Advance Comments Test Cycle ChartInputs Outputs Menu 3029Machine ID Menu Alarms MenusMachine Errors Rotation Sensor Error Air Flow Switch ErrorsAuto Ignition Retry Gas Models Only DIP Switch/Harness Index Mismatch Error Moisture Sensor ErrorFan Motor Contactor Error Fan Motor Centrifugal Switch ErrorLaundry Management Menus Laundry ManagementDaily Menu Service Service Schedule MenuMonthly Menu Service Quarterly Menu Service Bi-Annual Menu Service Quarterly Maintenance RemindersOFF Cycle Charts