Drying cycle complete / removing laundry

Putting in extra items or taking items out before end of programme

1.Open loading door

1Warning! Laundry and drum can become hot. Risk of burns!

2.Load or remove laundry items.

3.Close loading securely. Lock must audibly lock.

4.Press the START/PAUSE (START/PAUZE) button to continue the drying cycle.

Drying cycle complete / removing laundry

Once the drying cycle is complete, the END (EINDE) and CREASE GUARD (ANTI-KREUK) indicators light up. If the SIGNAL (ZOEMER) button has been pressed, an acoustic signal sounds intermittently.

3 The drying cycles (except for the WOOL (WOL) programme) are auto- matically followed by an anti-crease phase which lasts around 30 min- utes. The drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anti-crease phase. (The laundry should be taken out to- wards the end of the anti-crease phase at the latest to prevent creases from forming.) If LONG ANTICREASE (ANTI-KREUK) has been selected, the anti-crease phase is lengthened by 60 minutes.

1.Open door.

2.Before removing the laundry, remove fluff from the micro-fine filter. It is best to use a damp hand for this purpose. (See “Cleaning and mainte- nance” section.)

3.Remove laundry.

4.Turn the programme selector to OFF (UIT). Important: After each drying cycle

–Clean the micro-fine filter and fine filter

–Drain the condensed water container

(See section “Cleaning and maintenance”.)

5.Close door.