AEG 59800 manual Changing the bulb for interior lighting

Problem	Possible cause	Remedy
	Lint filter clogged.	Clean lint filter.
Drying cycle lasts an	Fluff filter clogged.	Clean fluff filter.
unusually long time.	Load volume too big.	Reduce load volume.
Note:
After around 5 hours	Laundry insufficiently spun.	Laundry must be adequately
the drying cycle ends		spun.
automatically (see
	Particularly high room tem-	Automatic process, there is no
„Drying cycle com-
	perature. Temporary switch-	fault with the appliance. If
plete“).
	ing off of the compressor to	possible, lower the room tem-
	avoid overload.	perature.

Changing the bulb for interior lighting

Only use a special bulb which is designed specially for dryers. The spe- cial bulb can be obtained from the Customer Care Department, ET no. 112 552 000-5.

3 Important: When the appliance is switched on, the interior lighting switches itself off after 5 minutes when the door is open.

1 Warning: Do not use standard bulbs! These develop too much heat and may damage the appliance.

1 Warning: Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully unscrew or deactivate the fuse.

1.Unscrew cover above the bulb (this can be found directly behind the loading aperture, at the top; refer to “Description of machine” section.)

2.Replace defective bulb.

3.Screw cover back down.

1Warning: For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer must not be operated.

24