AEG 56609 operating instructions 1Safety instructions, General safety

Page 5

Safety instructions

1Safety instructions

The safety of AEG electrical appliances complies with the established technical principles and statutory equipment safety regulations. Nevertheless, as manufacturer we have to draw your attention to the following safety instructions.

General safety

•Repairs of the dryer may be carried out only by trained personnel. Incompetently carried out repairs can entail considerable hazards for the user. Please get in touch with our customer service or with an authorised AEG dealer when repair is necessary.

•Before commencing operation please make sure that the nominal voltage and type of supply specified on the type plate of the appliance correspond to the actual nominal voltage and supply type at the place of utilisation. The fuse rating is also specified on the type plate.

•Never operate the dryer when the mains cable is damaged or when the operator control mask, work plate or base shrouding are damaged such that there is direct access to the interior of the appliance.

•Switch-off the dryer before carrying out any cleaning, care and maintenance tasks! You are quite safe if you disconnect the mains plug from the power outlet or – if the electrical connection is permanent – if you switch-off the circuit breaker in the fusebox or screw the fuse cartridge right out of its holder.

•Never pull on the cable to disconnect the mains plug from the power outlet. Always grasp and pull-out the plug.

•Don’t lean on the opened door; this could make the appliance fall over.

•Don’t use a water jet to spray-down the appliance. Danger of electric shock!

•The covering hood for the filament lamp bulb for drum illumination must be screwed-on.

•If you interrupt the drying process to take out laundry, bear in mind that the laundry and the drum could be hot.

•Adaptors and extension cables must not be used. There is risk of fire because of overheating!

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Lavatherm 56609 Exclusiv Please read these operating instructions through carefully Dear customerContent Content General safety 1Safety instructionsUtilisation in accordance with the intended purpose Safety of childrenInstallation and connection General information Dispose of the packaging material DisposalPre-drying Drying process Environmental protection tipsFill weight Duration Power Drying program Front view Construction of the applianceOperator control mask Program selector Before the first drying processBrief operating instructions Preparing the laundry DryingOpen the fill-in door Fill-in the laundryStart the drying program Switch-off the dryer Take-out laundry or put-in laundry when necessaryEnd of the drying process Take out the laundryEmpty the condensate container Clean the condenser Clean the fluff filterProgram tables Care symbols R, Q fill-in quantity up to 5kgCool AIR Program Small glossary of textile information Care symbolsCleaning the condenser Cleaning and maintenanceCleaning the panel and operating parts Cleaning the filter areaClean the drum Problem Possible cause Remedy TroubleshootingOFF Replace the filament bulb Changing-over the door stop Changing-over the door stop Information for the electrician Technical dataPower supply Kits Washing/drying column Special accessoriesKit for external condensate drain-off Use condensate Viscose Page When do you incur costs even during the warranty period? Service
Top Page Image Contents