Amana ND-68 important safety instructions Care and Cleaning, Replace Drum Light, Reverse the Door

Page 9

CARE AND CLEANING

Control Panel – Clean with a soft, damp cloth. Do not use abrasive substances. Do not spray cleaners directly on the panel.

Tumbler – Remove any stains such as crayon, ink pen or fabric dye (from new items such as towels or jeans) with an all-purpose cleaner. Then tumble old towels or rags to remove any excess stain or cleaning substance. Once these steps are done, stains may still be visible, but should not transfer to subsequent loads.

Cabinet – Wipe off any marks with soap and water.

Dryer Exhaust System – Should be inspected and cleaned once a year to maintain optimum performance.The outside exhaust hood should be cleaned more frequently to ensure proper operation. (Refer to the Installation Instructions for more information.)

REPLACE DRUM LIGHT

Instructions for replacing the bulb:

1) Unplug or disconnect the dryer from the electrical power supply.

2) Open the door and use a Phillips screwdriver to remove the screw attaching the lens to the tumbler front.

3) Remove lens cover by pulling cover toward center of tumbler.

4) Rotate bulb counterclockwise to remove from socket.

5)Replace the bulb with a 120 volt, 10 watt maximum candelabra base light bulb.

6)Turn the light bulb clockwise into socket.

7)Replace lens cover by hooking plastic tabs into tumbler front below the light housing.

8)Reinstall the screw into the lens cover screw hole.

9)Reconnect dryer to power supply.

REVERSE THE DOOR

Instructions for reversing the dryer door:

1) Remove the hinge hole covers and screws.

2) While supporting the door, remove 2 screws in the hinges that secure the hinges to the cabinet.

3) Remove door by lifting slightly at the hinges and pulling the hinge tabs out of the hinge slots.

4) Move the following parts to the opposite side of the door: 2 hinges and 4 hinge screws, 4 door screws, door strike and screw, inner door cover plate and screw.

5) Attach the door to the opposite side of the cabinet using the 2 counter sunk hinge screws. (See below). Screw the lower hinge screw in first.This will help to align the door and hinges.

6) Replace the hinge hole covers to the opposite side.

8

Image 9
Contents Dryer ND-68 What YOU Need to Know about Safety Instructions Important Safety InstructionsRecognize Safety SYMBOLS, WORDS, Labels For service and warranty information, seeImportant Safety Notice & Warning Dryer Exhaust Tips Operating Tips Clean the Lint FilterLoad the Dryer Properly ADD a Fabric Softener Sheet if DesiredUsing the Controls Select TemperatureSelect a Cycle Select Sensor Dry LevelSelect Cycle Options Indicator LightsStart the Dryer Estimated Time DisplaySpecial Laundry Tips Avoid Dryer DryingUse Sensor DRY Replace Drum Light Care and CleaningReverse the Door Instructions for replacing the bulbDoesn’t Run TroubleshootingTo Remove Rack Using the Drying RackAmana Major Appliance Warranty Secadora Información Sobre LAS Instrucciones DE Seguridad BienvenidaAviso Y Advertencia Importante Sobre Seguridad Conserve Estas InstruccionesSugerencias Para EL Escape DE LA Secadora Limpie EL Filtro DE LAS Pelusas Sugerencias Para EL FuncionamientoCargue LA Ropa EN LA Secadora EN Forma Adecuada Agregue UNA Hoja DE Suavizador DE Telas SI LO DeseaPaso 2 Selección del nivel del sensor de secado Paso 1 Selección el cicloPaso Selección la temperatura USO DE LOS ControlesPaso 5 Puesta en marcha de la secadora Paso 4 Selección de las opcionesDespliegue DEL Tiempo Estimado Luces IndicadorasSugerencias Especiales Para EL Lavado Evite Secar EN LA SecadoraUse ‘SENSOR DRY’ Reemplazo DE LA LUZ DEL Tambor Cuidado Y LimpiezaInversión DE LA Puerta Instrucciones para reemplazar el focoVerifique LO Siguiente SI SU Secadora AMANA… Solución DE ProblemasRejilla DE Secado Modelos Selectos USO DE LA Rejilla DE SecadoPara retirar la rejilla DE Amana