JVC KD-S891R manual Tuning in to a preset station, Manual preset, P1 flashes for a few seconds

Manual preset

You can preset up to 6 stations in each band (FM1, FM2, FM3, and AM) manually.

Ex.: Storing FM station of 92.5 MHz into the preset number 1 of the FM1 band.

1 Select the band (FM1 – 3, AM) you want to store stations into (in this example, FM1).

Each time you press the

button, the band changes as

follows:

FM1 FM2 FM3 AM

2 Tune in to a station (in this example, of 92.5 MHz).

To tune in to stations of higher frequencies

To tune in to stations of lower frequencies

3 Press and hold the number button (in this example, 1) for more than 2 seconds.

“P1” flashes for a few seconds.

4 Repeat the above procedure to store other stations into other preset numbers.

Notes:
		ENGLISH
•	A previously preset station is erased when a new
	station is stored in the same preset number.
•	Preset stations are erased when the power supply to
	the memory circuit is interrupted (for example,
	during battery replacement). If this occurs, preset
	the stations again.

Tuning in to a preset station

You can easily tune in to a preset station. Remember that you must store stations first. If you have not stored them yet, see “Storing stations in memory” on pages 8 and 9.

1 Select the band (FM1 – 3, AM).

Each time you press the button, the band changes as follows:

FM1 FM2 FM3 AM

2 Select the number (1 – 6) for the preset station you want.

Note:

You can also use the 5 (up) or ∞(down) button on the unit to select the next or previous preset stations. Each time you press the 5(up) or ∞(down) button, the next or previous preset station is tuned in.

9