Amana W10233410A manual Dryer Care, Cleaning the Dryer Location, Cleaning the Lint Screen

Page 24

DRYER CARE

Cleaning the Dryer Location

Keep dryer area clear and free from items that would obstruct the flow of combustion and ventilation air.

As needed cleaning

Laundry detergent and fabric softener residue can build up on the lint screen. This buildup can cause longer drying times for your clothes, or cause the dryer to stop before your load is completely dry. The screen is probably clogged if lint falls off while the screen is in the dryer.

Clean the lint screen with a nylon brush every 6 months, or more frequently, if it becomes clogged due to a residue buildup.

To wash

1.Roll lint off the screen with your fingers.

2.Wet both sides of lint screen with hot water.

3.Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.

Cleaning the Lint Screen

Every load cleaning

The lint screen is located in the door opening of the dryer. The control panel has an indicator light to remind you to clean the lint screen before each load. A screen blocked by lint can increase drying time.

To clean

1.Pull the lint screen straight up. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet lint is hard to remove.

2.Push the lint screen firmly back into place.

IMPORTANT:

Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can cause overheating and damage to both the dryer and fabrics.

Some towels made of synthetic fibers and natural fibers (polyester and cotton blends) may shed more lint than other towels, causing your dryer’s lint screen to fill up faster. Be sure to remove lint from the lint screen before and after drying new towels.

If lint falls off the screen into the dryer during removal, check the exhaust hood and remove the lint. See “Venting Requirements.”

4.Rinse screen with hot water.

5.Thoroughly dry lint screen with a clean towel. Replace screen in dryer.

Cleaning the Dryer Interior

To clean dryer drum

1.Make a paste with powdered laundry detergent and very warm water.

2.Apply paste to a soft cloth.

OR

Apply a liquid, nonflammable household cleaner to the stained area and rub with a soft cloth until all excess dye and stains are removed.

3.Wipe drum thoroughly with a damp cloth.

4.Tumble a load of clean cloths or towels to dry drum.

NOTE: Garments that contain unstable dyes, such as denim blue jeans or brightly colored cotton items, may discolor the dryer interior. These stains are not harmful to your dryer and will not stain future loads of clothes. Dry unstable dye items inside out to avoid transfer of dye.

Removing Accumulated Lint

From Inside the Dryer Cabinet

Lint should be removed every 2 years, or more often, depending on dryer usage. Cleaning should be done by a qualified person.

From the Exhaust Vent

Lint should be removed every 2 years, or more often, depending on dryer usage.

24

Image 24
Contents Table of Contents W10233410ATable of Contents Dryer SafetyPage Installation Instructions Tools and PartsOptional Pedestal Location RequirementsInstallation clearances Dryer DimensionsCustom undercounter installation Dryer only Closet installation Dryer onlyInstallation spacing for cabinet installation Mobile home additional installation requirementsElectrical Requirements It is your responsibilityIf connecting by direct wire If your outlet looks like thisPower Supply Cord Direct Wire Style 1 Power supply cord strain reliefInstall strain relief Electrical ConnectionWire connection Power supply cord Style 2 Direct wire strain reliefRemove center, silver-colored terminal block screw Wire connection Direct wire BDE CG F Optional 3-wire connection If using an existing vent system Venting RequirementsIf this is a new vent system Vent material Optional exhaust installations Plan Vent SystemDo not use an exhaust hood with a magnetic latch Install Vent System Alternate installations for close clearancesVent system chart Special provisions for mobile home installationsInstall Leveling Legs Remove the door assemblyLevel Dryer Connect VentRotate outer door Reverse hingeReverse the strike Complete Installation Reinstall the doorReattach door to dryer front panel with the 4 screws If the dryer will not start, check the followingPress Stop once Adjust Dryness Level and/or Options To use an Auto CycleStopping or Restarting Your Dryer Drying and Cycle TipsStatus Lights Lock ControlsCycles Modifiers OptionsChanging Cycles, Options, and Modifiers Drying Rack OptionsRack Dry Setting Temp Time Wool Sweaters To use the drying rackStuffed toys or pillows Sneakers or canvas shoesCleaning the Dryer Location Cleaning the Lint ScreenCleaning the Dryer Interior Dryer CareTroubleshooting Vacation and Moving CareChanging the Drum Light Dryer OperationDryer Results Dryer displaying code messageCycle time too short Assistance or Service Amana Laundry Warranty This limited warranty does not coverW10233410A