Amana W10233410A manual To use the drying rack, Rack Dry Setting Temp Time Wool Sweaters

Page 23

To use the drying rack

Do not remove the lint screen.

1.Open dryer door.

A

A. Front edge

2.Place drying rack inside dryer drum, positioning the back wire on the ledge of the inner dryer back panel. Push down on front edge of drying rack to secure over the lint screen.

B

A

A. Drying rack front edge

B. Dryer back panel

3.Put the wet items on top of the drying rack. Leave space between the items so air can reach all the surfaces.

NOTE: Do not allow items to hang over the edge of the drying rack.

4.Close the door.

5.Press the POWER button.

6.Select a timed cycle and temperature (see following chart). Items containing foam, rubber, or plastic must be dried on a clothesline or by using the Air Dry temperature setting.

7.You may change the cycle time by pressing MORE TIME or LESS TIME. Reset time as needed to complete drying. Refer to the following table.

8.Press (and hold) START button (about 3 seconds).

NOTE: You must remove drying rack for normal tumbling. Do not use auto cycles with the drying rack.

This chart shows examples of items that can be rack dried and the suggested temperature setting and drying time. Actual drying time will depend on the amount of moisture items hold.

Rack Dry

Setting

Temp.

Time*

Wool Sweaters

Timed

Low

60

Block to shape and lay flat on

cycles

 

 

 

 

 

the drying rack.

 

 

 

 

 

 

 

Stuffed toys or pillows

Timed

Low

60

Cotton or polyester fiber filled

cycles

 

 

 

 

 

 

 

 

 

Stuffed toys or pillows

Timed

Air Dry

90

Foam rubber filled

cycles

(no heat)

 

 

 

 

 

 

 

 

Sneakers or canvas shoes

Timed

Air Dry

90

 

cycles

(no heat)

 

 

 

 

 

*(Minutes) Reset time to complete drying, if needed.

23

Image 23
Contents W10233410A Table of ContentsDryer Safety Table of ContentsPage Location Requirements Installation InstructionsTools and Parts Optional PedestalCloset installation Dryer only Installation clearancesDryer Dimensions Custom undercounter installation Dryer onlyIt is your responsibility Installation spacing for cabinet installationMobile home additional installation requirements Electrical RequirementsIf your outlet looks like this If connecting by direct wireElectrical Connection Power Supply Cord Direct WireStyle 1 Power supply cord strain relief Install strain reliefRemove center, silver-colored terminal block screw Wire connection Power supply cordStyle 2 Direct wire strain relief Wire connection Direct wire BDE CG F Optional 3-wire connection If this is a new vent system Vent material If using an existing vent systemVenting Requirements Do not use an exhaust hood with a magnetic latch Optional exhaust installationsPlan Vent System Special provisions for mobile home installations Install Vent SystemAlternate installations for close clearances Vent system chartConnect Vent Install Leveling LegsRemove the door assembly Level DryerReverse the strike Rotate outer doorReverse hinge If the dryer will not start, check the following Complete InstallationReinstall the door Reattach door to dryer front panel with the 4 screwsTo use an Auto Cycle Press Stop once Adjust Dryness Level and/or OptionsLock Controls Stopping or Restarting Your DryerDrying and Cycle Tips Status LightsCycles Drying Rack Options ModifiersOptions Changing Cycles, Options, and ModifiersSneakers or canvas shoes Rack Dry Setting Temp Time Wool SweatersTo use the drying rack Stuffed toys or pillowsDryer Care Cleaning the Dryer LocationCleaning the Lint Screen Cleaning the Dryer InteriorDryer Operation TroubleshootingVacation and Moving Care Changing the Drum LightCycle time too short Dryer ResultsDryer displaying code message Assistance or Service W10233410A Amana Laundry WarrantyThis limited warranty does not cover