INSTALLATION INSTRUCTIONS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Optional Pedestal
Are you placing the dryer on a pedestal? You have the option of purchasing pedestals of different heights separately for this dryer. You may select a 10" (254 mm) pedestal or a 15.5" (394 mm) pedestal with a storage drawer. The pedestal will add to the total
■Flat-blade screwdriver
■#2 Phillips screwdriver
■Adjustable wrench that opens to 1" (25.4 mm) or
■Wire stripper (for direct wire installations)
■Level
■Vent clamps
■Caulking gun and compound (for installing new exhaust vent)
■Tin snips (new vent installations)
■¼" nut driver or socket wrench (recommended)
■Tape measure
height of the dryer for a total height of approximately 46" (1168 mm) or 51.5" (1308 mm), respectively.
For a garage installation, you will need to place the 10" (254 mm) pedestal at least 9" (229 mm) above the floor. You will need to place the 15.5" (394 mm) pedestal at least 3" (76 mm) above the floor.
Parts supplied
Remove parts package from dryer drum. Check that all parts are included.
4 Leveling legs
NOTE: Do not use leveling legs if installing the dryer on a pedestal.
Parts needed
Check local codes. Check existing electrical supply and venting. See “Electrical Requirements” and “Venting Requirements” before purchasing parts.
■For
Optional pedestal (15.5" [394 mm] model shown)
To order, call the dealer from whom you purchased your dryer or refer to the “Assistance or Service” section.
Pedestal Height | Color | Part Number |
|
|
|
10" (254 mm) | White | WHP1000SQ |
|
|
|
15.5" (394 mm) | White | XHP1550VW |
Stack Kit
Are you planning to stack your washer and dryer? To do so, you will need to purchase a Stack Kit.
To order, call the dealer from whom you purchased your washer or refer to the “Assistance or Service” section. Ask for Part Number 8572546.
Location Requirements
34.15" |
|
(867.4 mm) |
|
Mobile home installations require metal exhaust system hardware |
|
available for purchase from the dealer from whom you purchased |
|
your dryer. For further information, please refer to the “Assistance |
|
or Service” section. |
|
If using a power supply cord: |
|
Use a UL listed power supply cord kit marked for use with |
|
clothes dryers. The kit should contain: |
|
■ A UL listed |
|
120/240 volt minimum. The cord should be type SRD or |
|
SRDT and be at least 4 ft (1.22 m) long. The wires that |
|
connect to the dryer must end in ring terminals or spade |
|
terminals with upturned ends. |
|
■ A UL listed strain relief. | You will need |
| ■ A location that allows for proper exhaust installation. See |
| “Venting Requirements.” |
| ■ A separate |
4