INSTALLATION REQUIREMENTS
TOOLS AND PARTS
Gather the required tools and parts before starting installation.
Tools needed:
|
|
|
| #2 Phillips screwdriver | |
|
|
|
|
|
|
Wire stripper (direct wire | Tin snips (new vent |
installations) | installations) |
Parts supplied (all models):
Leveling legs (4)
Parts supplied (steam models):
|
|
|
1/4" nut driver | Vent clamps | |
(recommended) |
|
“Y” connector
Long inlet hose
Short inlet hose
Rubber washer
|
|
|
Adjustable wrench that |
| Utility knife |
opens to 1" (25mm) or |
|
|
|
|
Parts package is located in dryer drum. Check that all parts are included.
NOTE: If installing dryer on pedestal, do not use leveling legs.
Optional Equipment: (Not supplied with dryer)
Refer to your Use and Care Guide for information about accessories available for your dryer.
Parts needed: (Not supplied with dryer)
Check local codes. Check existing electrical supply and venting. See “Electrical Requirements” and “Venting Requirements” before purchasing parts.
Tape measure
Level
Pliers |
Caulking gun and compound (for installing new exhaust vent)
Check code requirements. Some codes limit, or do not permit, installing dryer in garages, closets, mobile homes, or sleeping quarters. Contact your local building inspector.
3